Transcript
Assembly Instructions for Model: EFB Assemble your Sanus Systems Model EFSat, or HTB Speaker Foundation, attaching the L-Bracket. You will need the EFB Universal Mounting Bracket (sold separately) to mount the speakers. Use a Phillips screwdriver to remove the two plastic wall spacers that are on the back of your speaker, located just above the speaker terminal plate. Pull the speaker wires through the wire management and connect them to your speaker; then, lay the speaker down with the back facing up. Speaker Wires Open the EFB Package and remove the small Black Spacers and place them over the holes in the back of your speaker where the two plastic wall spacers were removed. Align the top two slots of the EFB over the two small Black Spacers. Using a Phillips screwdriver, and the two Screws provided with the EFB, secure the EFB and Spacers to the speaker, taking care as to not overtighten the screws. Spacers EFB Screws Slide the Speaker and EFB onto the L-Bracket on the stand. Speaker EFB L-Bracket Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 2.03.06 (100007) Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
