Download Lightolier IS:E610 User's Manual

INSTRUCTION
READ AND UNDERSTAND THESE INSTRUCTIONS
SHEET NO.
IS:E610
INSTALLATION OF PRE-WIRED CALCULITE FRAME-IN-KllS
INSTRUCTION SHE~ FOR ITEMS
G41O, E61O, F71O
R0291
Page 1 of 2
BEFORE INSTALLING FIXTURE.
This fixture is intended for installation
in accordance with the National Electrical Code and local regulations.
To assure full compliance
with local codes and regulations, check with your local electrical inspector before installation.
electrical shock, turn off electricity at fuse box before proceeding.
Retain these Instructions for maintenance
referencw
To prevent
..
‘a-.”-:
R
RETAINING
SPRING
,l#G
T
ti:EmoR
SECTION
HOUSING
B. CLOSE.IN
A. FRAME-IN
FIG.
1
WARNING+RISK
WIRING
b. PUSH-IN
C. SNAP-IN
FIG. 2
FIG. 3
FIG. 4
OF FIRE)DO NOT INSTALLinSUlatiOn WITHIN3 INCHESOF FIXTURESIDES OR
COMPARTMENT,
NOR ABOVE FIXTURE
IN SUCH A MANNER
SO AS TO ENTRAP
HEAT.
A. FRAME-IN AND WIRE-IN (FIG. 1)
1, Install FRAME-IN SECTION using ADJUSTABLE
MOUNTING BRACKET (see below). Wire to supply leads. White fixture lead
to neutral supply lead. Black fixture lead to hot (120V.) supply lead. Bare fixture wire to supply ground. Use wirenuts (local
hardware items). Place all electrical connections
in the J-BOX. Attach J-BOX COVER onto J-BOX.
s
2. Adjust
MOUNTING
FRAME,
-
a. For Flangeless Trim
Plaster Ceiling.
FIG. 9
Set MOUNTING FRAME so the
bottom edge is flush with finished
1-1<31-170
:?
[-3
MOUNTING
FRAME
;
– MOUNTING
FRAME
FIG. 8
.J
Set MOUNTING FRAME so the bottom edge
is flush with, no higher than %“ above finished
as shown.
1-11=
I?”
;V:::::L,N::EV::,
31,
” Max
T
@
o
ceiling,
b. For Overlapping Trim
Plaster or Dry Ceiling.
ceiling,
as shown.
E:A:Y:;
“—-—
NOTE
1. To insure proper Installation,
ceiling members.
2. To insure propar Installation,
ceiling members
B. CLOSE-IN (FIG. 2).
Close in ceiling
required.
the MOUNTING
FRAME must always be secure to structural
the MOUNTING
FRAME must always be secure to structural
C. SNAP-IN (FIG. 3)
D. PUSH-IN (FIG. 4)
}
SEE SEPARATE
REFLECTOR TRIM
INSTRUCTION
SHEETS
...
U.S. Pat. No. 4,039,822
-.