Transcript
Refilling Instructions for Hewlett-Packard 51641A Tri-Color Cartridge CONTENTS: dispensing ink as soon as ink starts to overflow from 6. Stop the fill hole. Release the pressure from the bottle so that a PLACE OVER ORIGINAL LABEL FOR CORRECT COLOR CODING 3 Refill Inks Cyan, Magenta, Yellow LETT D HEW AR hp PACK 51 64 1A MADE IN U.S.A. HP small amount of the excess ink is drawn back into the bottle. Cotton Wipe Color Sequence Label Remove ink cartridge from printer and protect work surface. Refilling your cartridge is a clean & simple job, but it is best to cover your work area with newspaper or paper towel to protect from accidental spills. Your 51641A Tri-Color Cartridge 1. Affix color sequence label over original cartridge label. 2. Holding the cartridge as shown in Illustration 1, use the the dispenser from the cartridge. Recap the 7. Remove dispenser and save for future use. 8. 9. T LETD HEWKAR hp PAC tip of a ball point pen, or similar object, to push the three plugs which seal the ink fill holes into the cartridge. 51 64 1A Repeat the fill procedure with the other two colors so that all three ink chambers are topped off. There is no need to reseal the fill holes. Ink will not leak from them. MADE IN U.S.A. HP Use the cotton wipe to dry any overflow from around the fill hole. Illustration 1 3. Using the colored dots on the cartridge label as a guide determine which of the 3 ink chambers is empty. Select the corresponding ink dispenser (cyan, magenta or yellow). Remove the scabbard from the dispenser tip. IF YOU HAVE ANY QUESTIONS OR ENCOUNTER ANY DIFFICULTY IN USING THIS PRODUCT, PLEASE CONTACT: 4. Tilt the cartridge forward so that you can insert the dispenser tip into the correct hp TTD LE R W A E K H AC A P 1 4 6 1 5 HP fill hole without dripping (Illustration 2). Insert the dispensertip into the cartridge as far as it will go. .A. MA DE IN U.S Illustration 2 MANUFACTURING CORPORATION ESTABLISHED 1931 665 State Highway 23 • Wayne, NJ 07470-6892 U.S.A. • (973) 696-3330 • (800) 288-3330 Fax: (973) 694-7287 • Email: [email protected] 5. Bring the cartridge and dispenser back to the vertical position. Gently squeeze the dispenser bottle while slowly drawing the tip upward so that the ink saturates all areas of the foam sponge inside the ink chamber (Illustration 3). Hewlett-Packard is a trademark of Hewlett-Packard Company. ©1998 Repeat-O-Type Manufacturing Corporation. ETT HEWLARD hp PACK 164 1A MADE IN U.S.A. HP 5 Illustration 3 51641A Refill Instr. 12/97
