Transcript
Quick Start Guide ST59-23H1 23" Liquid Crystal Display TV This guide is designed as a reference to help you start using your LCD TV quickly. Please refer to the User's Manual for more detailed installation and safety instructions. Front View Rear View AV5 DV MENU LINE IN R LINE OUT L R L AV1 Rr Pb Y R L AV2 VIEDO S-VIEDO R AV3 L VIEDO AN DC IN AUTO/MUTE SOURCE S VIDEO L R VIDEO AV4 Earphone jack AV4 Speaker MENU Menu Channel Power Select Remote IR sensor Volume Source Adjust AUTO/MUTE AV 1 LINE OUT DVI LINE IN DVI LINE IN R AUTO/MUTE SOURCE L R L Pr AV 2 Pb Y R AV1 L AV 3 VIDEO S-VIDEO R L AV2 VIDEO AV3 Making Connections Getting Started Connecting to Antenna/Cable TV/ PC/AV Devices Watching Broadcast or Cable TV 1. Press the POWER button to turn on your LCD TV. 2. Press the SOURCE button to select "TV". 3. Press the MENU button to open the OSD menu. 4. Press the CH or CH button to select "TV". 5. Press the VOL + button to enter "TV MENU". 6. Press the CH or CH button to select "SYSTEM". 7. Press the VOL + button to select "AUTO, B/G, D/K, I". MENU DV DVI LINE IN L R LINE OUT L R L AV1 Rr Pb Y R L AV 1 LINE OUT R LINE IN R L Pr AV2 VIEDO S-VIEDO R AV3 L VIEDO AN DC IN AV 2 Pb Y R L VIDEO S-VIDEO ANT Jack (VHF/UHF IN Jack) AV 3 R L VIDEO ANT DC-IN AV3 Audio cable Video connector Audio connector DC-IN AUTO/MUTE SOURCE Selecting A/V Sources Antenna/CATV coaxial cable DVI cable DC-IN ANTENNA/ CABLE TV LINE OUT Antenna ANT 1. Make sure your TV is turned on and a device such as a DVD player is connected. 2. Press SOURCE key on the control panel to select different source signals. The TV channel number, PC or AV1 ~ AV5 appears on the screen. TV PC AV1 AV2 AV3 AV4 AV5 MENU AUTO/MUTE SOURCE S VIDEO L R VIDEO AV4 R L VIDEO VCR VCD DVD Connecting the Power Adapter Power outlet DV DVI LINE IN L R LINE OUT L R L AV1 Rr Pb Y R L AV2 VIEDO AV 1 LINE OUT R LINE IN R L Pr S-VIEDO R AV3 L VIEDO AN 2. Plug the power adapter connector into the DC-IN input jack on the rear panel of the TV. DC IN AV 2 Pb Y R L VIDEO S-VIDEO 1. Connect the power cord to the power adapter as illustrated. AV 3 R L VIDEO ANT DC-IN Power cord DC-IN 3. Insert the three-pronged plug at the other end of the power cord into a power outlet. Note : Images are for illustration only and may vary by model or region. Auto Channel Setup Please follow the instructions by using the control panel. 1. Press the MENU button to enter the OSD menu. 2. Use the CH button to select "TV". 3. Press the VOL + button to enter the TV setting. 4. Press the CH button until the "Auto Program" feature is selected. 5. Press the VOL + button to begin "Auto Program". 6. Your television will begin automatically memorizing the available channels. TV Menu TV SYSTEM B/G CH SKIP AUTO PROGRAM OFF FINE TUNE STEREO MPX FAV. CHANNEL RETURN : SELECT Auto Program 698.40 MHZ 79% : ADJUST MENU : CLOSE Power adapter Copyright 2005, Hannspree, Inc. All rights reserved. MAD-001414