Transcript
TRADITIONAL BIDET VITREOUS CHINA TRADITIONAL BIDET ❑ 5065.040 For deck-mounted fitting (illustrated) •Vitreous china •Flushing rim and vertical cleansing spray •Design matched to Reminiscence and Enfield toilets •Two bolt caps •Integral overflow Shown with 8391.000 Amarilis bidet fitting with 0000.452 Jasmine metal cross handles (not included) ❑ 5065.010 For over-the-rim fitting •Vitreous china •Punched for single hole, over-the-rim fitting, less flushing rim and spray •Design matched to Reminiscence and Enfield toilets •Integral overflow •Two bolt caps FOOT OUTLINE 1-3/4 DIA. DRAIN OUTLET 76mm (3) MIN. OVERFLOW 127mm (5) 268mm (10-1/2) 406mm (16) 203mm (8) Nominal Dimensions: 600 x 406 x 394mm (26" x 16" x 15-1/2") 102mm (4) 29mm (1-1/8) FINISHED WALL 286mm (11-1/4) SPRAY Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Fawn Beige ❏ Black ❏ Bidet Fitting*: ❏ Fitting Finish: ❏ Trap: ❏ Supplies with Stops: OFFSET WASTE C/L 660mm (26) 178mm (7) 3/8 FLEX C.W.T. SUPPLIES FROM FITTING 394mm (15-1/2) "A" 1-1/4 O.D. TAILPIECE (FOR WALL DRAIN OUTLET ONLY) "A" FINISHED FLOOR 10mm (3/8) DIA. MTG. HOLES (2) ON 178mm (7) CTRS * See faucet section for additional models available 413mm (16-1/4) NOTES: * DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES ARE SUGGESTED. 140mm (5-1/2) 165mm (6-1/2) * 76mm (3) ▲ WALL OUTLET INSTALLATION REQUIRES: - A TRUE 1-1/4" BODIED “P” TRAP,; DO NOT USE A UNIVERSAL 1-1/4 X 1-1/2" TRAP. - WALL OUTLET INSTALLATION. - DRAIN TAILPIECE MUST BE CUT TO 1-1/2" LENGTH FOR WALL OUTLET CONNECTION. 1-1/4 O.D. TAILPIECE (FOR THRU FLOOR TRAPPING ONLY) 76mm (3) 3/8 N.P.T. SUPPLIES FINISHED FLOOR ■ THRU-FLOOR OUTLET INSTALLATION (ALTERNATE). 1-1/4 O.D. WASTE OUTLET C/L OF BIDET 29mm (1-1/8) OFFSET 102mm (4) 178mm (7) VIEW "A" - "A" (WALL SUPPLIES/OUTLET DETAIL) “P” TRAP AND FITTINGS NOT FURNISHED WITH BIDET AND MUST BE ORDERED SEPARATELY. BIDET FITTING HAS TRANSFER VALVE FEATURE. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard A112.19.2. These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet. © 2008 AS America Inc. K5 Revised 2/08