Transcript
CADET™ ROUND FRONT ONE-PIECE TOILET VITREOUS CHINA CADET™ ROUND FRONT ONE-PIECE TOILET ❑ 2099.016 •Vitreous china •Low-consumption (6.0 Lpf/1.6 gpf) •One-piece design •Round front siphon action jetted bowl with 2" trapway •Rim height at 381mm (15") •Color-matched trip lever •2 bolt caps •Internal trapway area fully glazed •100% factory flush tested •Seat not included Nominal Dimensions: 711 x 457 x 679mm (28" x 18" x 26-3/4") Fixture only, seat and supply by others FINISHED WALL Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball Pass Diameter, Trap Seal Depth and all Dimensions 711mm (28) 16 ± 6mm (5/8 ± 1/4) 206mm (8-1/8) C/L OF SEAT POST HOLES 140mm (5-1/2) CENTERS 397mm (15-5/8) 422mm (16-5/8) 679mm (26-3/4) SUPPLY AS REQ'D FINISHED FLOOR 79mm (3-1/8) To Be Specified: ❑ Color: ❏ White ❏ Bone ❏ Linen ❏ Silver ❏ Silver ❏ Black ❑ Trip Lever: 047242-XXX0A ❑ Color-matched (supplied) ❑ 002 Chrome ❑ 099 Polished Brass ❑ 295 Satin Nickel ❏ Supply with Stop: ❏ Seat: 375mm (14-3/4) *140mm (5-1/2) 16mm (5/8) 159mm (6-1/4) 305mm (12) 324mm (12-3/4) C/L OF OUTLET *133mm (5-1/4) FINISHED FLOOR 244mm (9-5/8) 457mm (18) NOTES: THIS TOILET IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. * DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. © 2008 AS America Inc. K17 Revised 2/08