Transcript
ERGOTECH GROUP, INC. 8 Westchester Plaza Elmsford, NY 10523 9143473800 Installation Instructions Product # 100-D28-B11 – Dual Vertical Desk Stand 1. Check to see that small hex set screw at rear of base is backed out enough to allow pole to seat down completely. Insert pole into base. Tighten set Special screw, usingInterest 3mm Allen key provided.. Articles: 2. Loosen ratchet type handle on pole clamp monitor mounting block. Slide clamp and block down pole • Add a highlight and tighten. Repeat for upper assembly. or your point of Note: position along pole will depend on size of interest here. monitors being mounted. These heights can be adjusted the monitors are mounted. • Addafter a highlight or your point of 3. Attachinterest quick here. release pivots to back of each monitor with screws provided. Be sure that silver release button is toward the top of the monitor. • Add a highlight or your point of 4. Placeinterest each here. monitor on its mounting block by tipping back approximately 45 degrees and then down until the silver release button engages hole on block. It will click into place. 5. Repeat for upper monitor. To adjust monitors: Left/Right and Up/Down: Grasp monitor with both hands and adjust to desired position. To tension the vertical adjustment to the weight of monitor: Tighten the 5mm bolt on the right side of the pivot with the hex wrench provided. To remove monitor: Take the weight from the monitor with one hand on the bottom and tip back slightly while using the other hand to lift the top of the silver release button. Lift up and back and this will release the monitor from the stand. OCT-08 www.ergotechgroup.com
