Download Chief CMS390
Transcript
INSTALLATION INSTRUCTIONS 16"/24" Adjustable On-Center Ceiling Plate Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description CMS390/CMS391 CMS390/CMS391 Installation Instructions DISCLAIMER Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document. Chief® is a registered trademark of Milestone AV Technologies. All rights reserved. IMPORTANT SAFETY INSTRUCTIONS WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. WARNING: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided. WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component. WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the CMS390/391 up to (and including) the display/projector does not exceed 500 lbs (226.80kg). WARNING: Use this mounting system only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. 2 WARNING: Never operate this mounting system if it is damaged. Return the mounting system to a service center for examination and repair. WARNING: Do not use this product outdoors. --SAVE THESE INSTRUCTIONS-- Installation Instructions CMS390/CMS391 DIMENSIONS CMS390 224.147 8.825 95.250 3.750 1.1/2" - 11.5 NPT TREADS 66.675 2X 2.625 119.063 2X 4.688 ADJUSTABLE BOTH DIRECTIONS 41.275 1.625 2X 14.597 .575 190.500 7.500 12.700 2X .500 371.475 14.625 22.225 .875 9.906 .390 10 - 24 UNC THREADS 81.332 3.202 406.400 16.000 9.906 .390 49.181 1.936 2X 79.742 3.139 448.295 17.649 DIMENSIONS: [MILLIMETERS] INCHES CMS391 325.747 12.825 1.1/2" - 11.5 NPT TREADS 66.675 2.625 220.663 2X 8.688 ADJUSTABLE BOTH DIRECTIONS 95.250 3.750 2X 41.275 1.625 2X 14.597 .575 4X 12.700 .500 190.500 7.500 406.400 16.000 574.675 22.625 609.600 24.000 22.225 .875 4X 9.906 .390 10 - 24 UNC THREAD 81.332 3.202 9.906 .390 49.181 1.936 2X 79.742 3.139 651.495 25.649 DIMENSIONS: [MILLIMETERS] INCHES 3 CMS390/CMS391 Installation Instructions LEGEND 4 Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación Perforar Befestigungsteil lösen Bohrloch Desapertar fixador Fazer furo Allentare il fissaggio Praticare un foro Bevestiging losdraaien Gat boren Desserrez les fixations Percez un trou Phillips Screwdriver Adjust Destornillador Phillips Ajustar Kreuzschlitzschraubendreher Einstellen Chave de fendas Phillips Ajustar Cacciavite a stella Regolare Kruiskopschroevendraaier Afstellen Tournevis à pointe cruciforme Ajuster Open-Ended Wrench Remove Llave de boca Quitar Gabelschlüssel Entfernen Chave de bocas Remover Chiave a punte aperte Rimuovere Steeksleutel Verwijderen Clé à fourche Retirez By Hand Optional A mano Opcional Von Hand Optional Com a mão Opcional A mano Opzionale Met de hand Optie À la main En option Hex-Head Wrench Security Wrench Llave de cabeza hexagonal Llave de seguridad Sechskantschlüssel Sicherheitsschlüssel Chave de cabeça sextavada Chave de segurança Chiave esagonale Chiave di sicurezza Zeskantsleutel Veiligheidssleutel Clé à tête hexagonale Clé de sécurité Installation Instructions CMS390/CMS391 TOOLS REQUIRED FOR INSTALLATION 5/32" (included) #2 1/8" 1/4" PARTS A (1) [Ceiling plate] (CMS391 shown) B (2) 1/4-20 x 3-1/2" C (2) 1/4" D (1) 10-24 x 1/4" E (1) 5/32" 5 CMS390/CMS391 Installation Instructions INSTALLATION (column not shown) NOTE: The CMS390 and CMS391 ceiling plates attach to a 1-1/2" NPT threaded column in a finished ceiling with 16" on-center (CMS390) or 24" on-center (CMS391) wood joists. In addition, both the CMS390 and CMS391 can be installed in line on a single joist. 1. 6 (D) x 1(F Remove end caps from ceiling plate (A). (See Figure 1) (A) 1 2 3 x2 Figure 3 End caps Adjust Ceiling Plate Position Figure 1 2. Drill two 1/8" pilot holes into wood joists. 3. Install ceiling plate (A) to ceiling using two 1/4-20 x 3-1/2" lag bolts (B) and two 1/4" flat washers (C). (See Figure 2) 4. Re-install end caps onto ceiling plate (A). (See Figure 2) (A) 4 4 (C) x 2 3 ((B) x 2 Figure 2 5. Install 1-1/2" NPT threaded column (not included) into threaded collar on ceiling plate (A). 6. Install one 10-24 x 1/4" Phillips head screw (D) into threaded collar and tighten. (See Figure 3) 6 1. Loosen adjustment set screws. (See Figure 3) 2. Adjust plate to position. 3. Tighten screws loosened in Step 1. Installation Instructions CMS390/CMS391 7 CMS390/CMS391 Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8800-002126 Rev00 2011 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 10/11 Asia Pacific A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Office No. 1 on 12/F, Shatin Galleria 18-24 Shan Mei Street Fotan, Shatin, Hong Kong P 852 2145 4099 F 852 2145 4477