Download ATTACK DPX LAMBDA Instruction manual

damaged. Creation of tar and condensate in the feed hopper is a phenomenon accompanying wood
gasifying.
If the boiler was out of order for a longer time (switched off,broke down), it is necessary to use
extreme caution when putting into operation again. In not working boiler, the pump can be blocked,
water can leak or the boiler could get frost in winter.
Heating up and operation
Before you fire up the fuel, open the feeding door and push the pull rod of the heating up flap,
which is pulled out, back to the basic position, until the trimmer engages (like at the closed door,
see the picture).
Set the flue gas thermostat to „0°C“. Put the refractory adapting piece on the thin layer of wood (cca
50mm) through the upper door - there should be a 4-3cm gap inbetween. Put the chippings on this
layer. Then put the paper or the fire wool on the chippings. Put cca 2 layers of thin dry wood on the
top. Fill the chamber to the top with used firewood. Turn on the suction fan and shut the feeding
door to the gap of cca 15mm. Set the required water temperature (80-90°C) on the output regulator.
When it is burning sufficiently (cca 10 minutes), close the feeding door. Set the flue gas thermostat
to the operation position (with the white mark above, cca 90° to the right form the zero position it depends on the flue gas temperature, at which is the boiler shut down required after burning out of
the fuel).
Push backwards and down
Position after pushing backwards and down
CAUTION: During the operation, the pull rod of fuel cut-off flap must be shifted in
by door into closed flap position, otherwise the fan can be damaged.
To gasify wood, there must be a reduction zone in the boiler (a layer of charcoal on the ceramic
shaped piece in the feed hopper). The layer can be created by combustion of dry wood of proper
size. When wet wood is burned, the boiler is not working as a gasifying boiler and the consumption
12