Download Sharp BDHP210U - Blu-ray Disc Player Specifications

Transcript
Troubleshooting
Network (Continued)
Problem
Cannot download BD-LIVE contents.
Possible causes and solutions
• Is the LAN cable connected properly?
• Is the USB memory device properly connected? Check that the USB memory
device is connected to the BD STORAGE/SERVICE terminal of this Player.
• Check if the BD disc supports BD-LIVE.
• Check the setting for “BD Internet Access”. (Page 38)
Other
Problem
Possible causes and solutions
The TV operates incorrectly.
• Some TVs with wireless remote control capability may operate incorrectly when
using the remote control of this Player. Use such TVs away from this Player.
The Player heats up during use.
• When using this Player, the console cabinet may heat up depending on the usage
environment. This is not a malfunction.
STANDBY indicator will remain lit.
• When the AC cord is removed from the outlet, the STANDBY indicator will remain lit
for a short period. This is normal and is not a malfunction.
To Reset this Player
• If this Player receives strong interference from a source such as excessive static electricity, strong external noise, malfunction
of power supply, or voltage caused by lightning during use or a wrong operation is sent to the Player, errors like the Player not
accepting an operation may occur. Press and hold POWER on the Player until “
” appears on the front panel display
when the Player does not operate properly even after the power has been turned off. Then, after the STANDBY indicator is lit,
turn on the power.
• When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At this point, it may take
a few moments for the system processing to finish before the Player is ready for use. During the system processing, the
BD/DVD/CD mode indicator on the front panel display of the Player will blink. Once the system processing has finished, the
indicator will finish blinking and then light up normally. You can operate the Player when the BD/DVD/CD mode indicator is lit.
• Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must
be set again.
• When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the
problem, contact the nearest service center approved by SHARP.
On-screen Error Messages
Messages Relating to BD disc and DVD disc
• The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or the
operation is not correct.
Error message
Possible Error
• The disc cannot be played back with
this Player.
Incompatible disc.
• If you load a disc which cannot be
played with this Player (i.e. a scratched
disc), or if you load a disc upside down,
this message will appear, and the disc
tray will automatically pop out.
• Occurs if the loaded disc cannot be
played because it is a non-standard disc
or scratched, etc.
Suggested Solution
• Check the disc, and load it correctly.
• Remove the disc.
Cannot operate.
• Occurs if an operation is incorrect.
This USB memory is not formatted
properly. Please format the memory in
USB memory management.
• Occurs if there is a formatting error.
• Occurs if the USB memory is not
formatted with FAT 32/16.
• Format the USB memory again.
• Format the USB memory with your
PC.
The Connected USB Memory cannot
be used. It should be compliant with
USB 2.0
• Occurs if USB memory not compliant
with USB 2.0 High Speed (480Mbit/s) is
used (i.e. USB 1.0/USB 1.1).
• Connect USB 2.0 High Speed
(480Mbit/s) compliant USB memory.
Appendix
Cannot play.
—
47