Download TECH TIPS: RPM
Transcript
TECH TIPS: RPM USER MANUAL Brugg Wire Rope, LLC Device Layout Display Upper & Lower Rope Contact Surfaces Plug Gauge Adjustment Dial RPM Battery Case NOTE: See Reverse Side For Important Details On Selecting Desired Rope Type and Units On/Okay www.bruggrope.com www.brugg-drahtseil.ch Mode Measuring Mode STEP 1 STEP 2 .OWINSERTROPEBETWEEN CONTACTSURFACESAND DEVICEPLUGGAUGE &IRSTTURNADJUSTMENT DIALcounterclockwise TOOPENPLUGGAUGE STEP 3 4URNADJUSTMENT DIALclockwiseTO CLOSEPLUGGAUGE +EEPTURNINGUNTIL YOUHEARABEEP OR 9OURdiameterISNOWDISPLAYEDINMETRICORIMPERIALUNITS STEP 4 #ONTINUETOTURNADJUSTMENT DIALclockwiseUNTILYOUREACH ANDHEARANOTHERBEEP 9OURtensionISNOWDISPLAYEDINMETRICORIMPERIALUNITS STEP 5 .OWTURNDIAL counterclockwise TOREMOVEROPE FROM20- STOP! DO NOT perform repeated measurements at the same rope position. 0HONE53s4OLLFREE"25''s&AXsINFOELEVATORROPE BRUGGCOMsWWWBRUGGROPECOM 4EL£FONO%5s,LAMADAGRATUITA"25''s&AXsINFOELEVATORROPE BRUGGCOMsWWWBRUGGROPECOM Brugg Lifting_Brugg Wire Rope 0311 OR TECH TIPS: RPM USER MANUAL How To Select Type Of Rope or Required Units (A) and Recall Hoist Rope Measurements (B) TO CLEAR MEMORY: Press “Okay”AND“Mode” BUTTONSIMULTANEOUSLY AUTOMATIC STORAGE: RPM automaticallyHOLDSLAST 20 measurementsRECORDED BOTHDIAMETERANDTENSION 0RESSBUTTONTOPROCEED .OW PRESS 4O MEASURING MODE: SEE REVERSE for details on how to measure with RPM. 0RESSTOVIEW (A) Selecting Rope/Units 0RESS 0RESS 0RESS 0RESS TOSELECT Rope Type TOVIEW TOVIEW 0RESS 0RESS 0RESS 0RESS TOVIEW 0RESSTOVIEW TOVIEW 0RESS Unit auto returns to MEASURE MODE TOSELECT Units (B) Recalling Measurements 0RESS NOTE: 0RESSFOR 0RESSFORDIAMETER .OWPRESS TOSEE .OWPRESSTODISPLAYTENSION Press okay to Exit/Return to MEASURE MODE 0HONE53s4OLLFREE"25''s&AXsINFOELEVATORROPE BRUGGCOMsWWWBRUGGROPECOM 4EL£FONO%5s,LAMADAGRATUITA"25''s&AXsINFOELEVATORROPE BRUGGCOMsWWWBRUGGROPECOM Rope measurements must ONLY be taken on ropes that are completely stationary and the installation is secured against operation. Tool use should be limited to trained personnel familiar with these instructions. All rope installations must be secured against the possibility of free fall. Any staff taking measurements must be equipped with proper personal safety gear. ANY FAILURE TO FOLLOW OPERATING INSTRUCTIONS VOIDS THE WARRANTY OF THIS DEVICE.