Download PAL Instruction Manual

Transcript
Getting Started
The Wireless Controller
21
operated at a very close range, replace the
battery.
E
Inserting the Battery (Lithium Button Battery
CR2025)
Adjusting the LCD Screen
Rotating the LCD Panel
Tab
1 Press the tab in the direction of the
3
180°
Using the Wireless Controller
90°
Point the controller at the camcorder’s
remote sensor when you press the
buttons.
Subject can monitor the LCD screen
NOTES
The wireless controller may not work properly
when the remote sensor is situated under
strong light sources or direct sunlight.
If the wireless controller does not work, check
that [WL.REMOTE] is not set to [OFF
]
(
41).
When the camcorder cannot be operated with
the wireless controller, or when it can only be
LCD Backlight
You can switch the brightness of the LCD
screen to [NORMAL] or [BRIGHT].
MENU
(
24)
1 Turn on the camcorder.
Preparations
2
arrow and pull out the battery
holder.
Place the lithium button battery with
the + side facing up.
Insert the battery holder.
Open the LCD panel 90 degrees.
• You can rotate the panel 90 degrees
downward.
• You can rotate the panel 180 degrees
toward the lens (allowing the subject to
monitor the LCD screen while you use the
viewfinder). Rotating the panel 180
degrees is also useful if you wish to
include yourself when recording with the
self timer.