Download 2016 Eagle TT & FW Manual

JAYCO TOWABLE
SECTION 8-PLUMBING SYSTEMS
Turn the pump switch ON. Solution will be drawn into the fresh water tank. Turn
pump OFF when solution has been drawn into the tank. (NOTE: to aid in siphoning,
set the container on a surface approximately 2 feet off the ground) Drain valves must
be turned OFF.
6. Remove the chlorine container and finish filling the fresh water tank with clean
(potable) water until tank is full:
Keep the valves set on SANITIZE. Leave the hose attached to the City Water
Connection inlet, place other end of hose in a container of fresh water. Turn pump
ON. Fresh water will be siphoned into the tank. Turn pump OFF when tank is full.
Disconnect the hose from Utility Center.
7. After the recommended amount of sanitizing solution is in the tank, the water tank is
full, and cartridge water filter (if so equipped) bypassed or the filter is removed from
the full system canister water filter (if so equipped). Power to water heater should be
OFF. (both switches: Electric & LP GAS)
When the
fresh water tank is full:
Set valves to the DRY CAMPING setting. Turn the
pump ON and sanitized water will flow into the water
lines from the tank.
8. Open all hot water faucets one by one until water begins to flow continuously and a
chlorine smell is noticeable. Include outside shower faucets (if so equipped). Close
hot water faucets.
9. Open all cold water faucets one by one until water begins to flow continuously and
you smell chlorine. Include outside shower faucets (if so equipped). Close cold water
faucets.
10. Turn OFF the water pump.
11. Let the solution remain in the tank & lines for at least four hours when disinfecting
with 50-PPM residual chlorine. If a shorter time period is desired, then a 100-PPM
chlorine concentration should be permitted to sit in the system for at least one hour.
NOTE: To thoroughly sanitize the fresh water tank, the unit should be driven
around for a period of time allowing the solution to splash the sides and top of the
tank.
12. After the required period, drain the chlorine solution from the fresh water system (see
Draining the Fresh Water System).
Rinse the system with fresh water:
13. Fill the fresh water tank full of clean (potable) water. (Select from 1 of 2 methods
below)
1) Filling from a pressurized source: Set the valves to the POWER FILL TANK
setting. Connect a non-toxic drinking hose to the City Water Connection inlet.
Connect the other end of the hose to the pressurized
water source. Turn on the water source. When
tank is full, turn off the water source, disconnect
the hose from the water source first, then
disconnect from the Utility Panel.
2) Syphon filling from a water container: Set the valves
to the SANITIZE setting. Insert a hose into the City
Water Connection inlet, place other end of the hose in
a container of water. Turn pump ON to draw water
into the tank. After the tank is full, turn the pump
OFF.
8-20