Download LV 5800 Instruction Manual

Transcript
1. INTRODUCTION
1.2.3
Last Memory
The LV 5800 has a last-memory feature. When you turn ON the power, the LV 5800 starts up
with the same panel settings that were set when it was last turned OFF.
If the backup battery runs out, the last-memory feature will no longer work, and the internal
clock will be reset. If this happens, contact your local LEADER agent.
To continually use the last-memory and clock features, we recommend that you replace the
backup battery with a new one every five years after you purchase the LV 5800. You cannot
replace the backup battery yourself. To have the battery replaced, contact your local
LEADER agent.
1.2.4
Mechanical Shock
To prevent damage to the precise components used in this instrument, be careful not to
expose the instrument to other forms of severe mechanical shock. If the LCD breaks, grass
fragments may cause injury.
1.2.5
LCD Monitor
There may be pixels on the LCD monitor that do not turn ON or those that remain ON at all
times. This is not a malfunction.
1.2.6
Flickering of the LCD
The LCD on the LV 5800 supports many types of video signals. The LCD displays the input
SDI signal asynchronously and may flicker on the waveform display or picture display. The
LV 5800 stores the input SDI signal once to the frame memory, and then reads the memory
using the LCD sync signal, which is asynchronous to the input SDI signal. Therefore, flickers
may occur due to frame skip, which skips over certain frame memories, or frame repeat,
which reads certain frame memories twice.
1.2.7
About the Cabinet
Use a cabinet with one of the specified serial numbers.
Please be aware that you cannot attach the LV 5800 to any of the old cabinets with the serial
numbers listed below.
LR 2404, LR 2427, LR 2427A, LR 2400-AI, LR 2400-AM, LR 2400-VI, LR 2400-VM, and LR
2700-I
2