Download USER MANUAL

TROUBLE SHOOTING CHART
PROBLEM
Compressor
will not run
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
1. No power, or switch in OFF position
2. Blown fuse
3. Motor overheats
1. Make sure compressor switch is ON
2. Disconnect compressor from power
source, replace fuse. (Refer to
Specifications section for correct fuse)
3. Let compressor cool off for about 30
minutes for thermal overload switch reset
Thermal
Overload Protector
cuts out repeatedly
1. Lack of proper ventilation/ambient
temperature too high
2. Compressor valves failed
1. Move compressor to well ventilated area,
or area with lower ambient temperature
2. Replace compressor
Excessive knocking
or rattling
1. Worn bearing on eccentric or motor
shaft
2. Cylinder or piston ring is worn
1.
Service or replace compressor
2.
Service or replace compressor
Compressor air flow
lower than normal,
or can not pump to
higher pressures
1. Worn piston ring or inlet valve
1.
Service or replace compressor
SPECIFICATIONS
Part Nos. 30033/300P Portable
Motor Voltage:
12-volt
Motor Type:
Permanent Magnetic
Max. Intermittent Pressure:
150 PSI
Max. Duty Cycle:
33% (15 on / 30 off)
(Min. On/Off @ 72ºF & 100 PSI)
Continuous Use @ 72ºF & 30 PSI: 40 Minutes
Max. Current Consumption:
30 Amps
Fuse:
40 Amps
Inline Pressure Gauge:
100 PSI
Auto. Reset Thermal Protection:
Yes