Download TUTORIAL

EDHIS
Creating the Vehicles
Figure 5-5 Contact Surface dialog.
To add the contact surfaces, perform the following steps:
â Click on the CG and choose Contact Surfaces. The Contact
Surfaces dialog is displayed (see Figure 5-5), and we’re ready
to create the contact surfaces for the Buick.
â Click Add and enter Seat Bottom, followed by <Enter>.
â Interior is already selected as the default location to identify
this contact as an interior contact surface.
â Enter the coordinatesfor 3 corners of the seat bottom, as shown
in the table below:
Table 5-1 Seat Bottom Contact Surface Coordinates
Corners (Counter-clockwise)
5 - 10
First Corner
Middle Corner
Third Corner
x
-23.0
-3.0
-3.0
y
-3.0
-3.0
-23.0
z
1.0
-2.0
-2.0