Download LED Triple Derby

User’s manual
LED Triple
Derby
Table of content
1.
Safety instructions........................................................................................................................... 3
2.
Product description ......................................................................................................................... 4
Description ........................................................................................................................................... 4
3.
Installation....................................................................................................................................... 4
4.
Start Up........................................................................................................................................... 4
5.
Master Slave Mode ......................................................................................................................... 4
2/5
1. Safety instructions
FOR SAFE AND EFFICIENT OPERATION
Be careful with heat and extreme temperatureAvoid exposing it
to direct rays of the sun or near a heating appliance.
Not put it in a temperature bellow 41°F /5°C, or exceeding 95°F /35°C.
Keep away from humidity, water and dust
Do not place the set in a location with high humidity or lots of dust.
Containers with water should not be placed on the set.
Keep away from sources of hum and noise
Such as transformer motor, tuner, TV set and amplifier.
To avoid placing on un-stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust, or a wet soft cloth for stubborn dirt.
If out of work, contact sales agency immediately
Any troubles arose, remove the power plug soon, and contact with an engineer for repairing,
do not open the cabinet by yourself, it might result a
danger of electric shock.
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure
to hold the plug. When not using the player for an extended period of time
be sure to disconnect the plug from the receptacle.
3/5
2. Product description
LED Lightsource: 2x 9W LED, RGB 3in1,
Master Slave Mode
Sound Control Mode
Volt: AC240V 50 Hz
Powerconsumption: max 35W
Working temperatur: Indoor 0°C- +40°C
Wight: 5 kg
Size: 450L x 450B x 230H
Use: for Nightclubs, Entertainment Areas or Disco
Description: This Product uses extrem bright LEDs as lightsource. These are bright, well coloured,
hitproof, and they have a extreme long lifetime up to 100 000 h . Further advantages are less heat and
less powerconsumption. Instead of other products this one is able to work 24 hours without breaks.
3. Installation
1. You can mount this product in every position , make sure that there is a distance of min 1 m to
walls or flammable stuff. Be sure to mount he product well and don´t forget the ground.
2. Make sure to have the wright voltage and power..
3. Attention : the XLR connector is no DMX connector, never use DMX products or
controller in the line!!
4. Start Up
1. Connect the product to the powersource, now you are in music mode.
2. now the product reacts to music impuls.
3. with the potentiometer on the back you can controll the sensitivity of the mikrophon.
4. if there is no music signal for about 10 sec. it shuts down the motor and lightsource.
5. Master Slave Mode
1. Choice the product which you want to bot he master.
2. choice the desired sensitivity on the master.
3. connect all slave products in the lin with XLR plug.
4. every seitivity of the slave products have to be 0.
5. Now every slave reacts like the master do.
6. Attention : the XLR connector is no DMX connector, never use DMX products or
controller in the line!!
4/5
Importeur:
B & K Braun GmbH
Industriestraße 1
D-76307 Karlsbad
www.bkbraun.com
[email protected]
5/5
B10-200528-01