Download PDF Nokia E63 User Guide

To stop the background scans, select Menu > Tools >
Settings > Connection > Wireless LAN > Show WLAN
availability > Never. You can still manually scan for
available WLAN networks and connect to WLAN networks as
usual.
To increase the background scan interval, select Show WLAN
availability > Yes, and define the interval in Scan for
networks.
Q: Why can't I browse the web even though the
WLAN connection is working and the IP settings
are correct?
A: Check that you have defined the HTTP/ HTTPS proxy
settings correctly in the advanced settings of your WLAN
access point.
Q: How do I check the signal quality of my WLAN
connection?
Select Menu > Connectivity > Conn. mgr. > Active data
connections > Options > Details. If the signal quality is
weak or moderate, you may encounter connection problems.
Try again closer to the access point.
Q: Why do I have problems with the security
mode?
A: Check that you have configured the security mode
correctly, and that it is the same that the network uses. To
check the security mode the network uses, select Menu >
Connectivity > Conn. mgr. > Active data connections >
Options > Details.
Check also the following: you have the correct WPA mode
(preshared key or EAP), you have disabled all EAP types that
© 2010 Nokia. All rights reserved.
are not needed, and all the EAP type settings are correct
(passwords, user names, certificates).
Q: Why can’t I select a contact for my message?
A: The contact card does not have a phone number, an
address, or an e-mail address. Select Menu > Communic. >
Contacts, and edit the contact card.
Q: The note Retrieving message is shown briefly.
What is happening?
A: The device is trying to retrieve a multimedia message from
the multimedia messaging centre. This note is shown if you
have selected Menu > Communic. > Messaging >
Options > Settings > Multimedia message >
Multimedia retrieval > Always automatic. Check that the
settings for multimedia messaging are defined correctly and
that there are no mistakes in phone numbers or addresses.
See "Multimedia message settings", p. 57.
Q: How can I end the data connection when the
device starts a data connection again and again?
A: The device may be trying to retrieve a multimedia message
from the multimedia message centre. To stop the device from
making a data connection, select Menu > Communic. >
Messaging > Options > Settings > Multimedia
message > Multimedia retrieval > Manual to have the
multimedia messaging centre save messages to be retrieved
later, or Off to ignore all incoming multimedia messages. If
you select Manual, you receive a notification when there is
a new multimedia message that you can retrieve in the
multimedia message centre. If you select Off, the device does
not make any network connections related to multimedia
messaging.
127