Download User Manual

SECTION 7—SEAT
Adjusting the Seat Height
NOTE: For this procedure, refer to FIGURE 7.5.
NOTE: Use the chart to determine the desired height of the seat.
Seat Height
Minimum
Intermediate
Maximum
Sets of Seat Spacers
0
1
2*
Total Number of Spacers
0
2
4
Length of Mounting Screws
4 cm
6 cm
9 cm
NOTE: A maximum of two sets of spacers can be installed.
*NOTE: If the seat bracket kit for 5° tilt is installed, only one set of spacers or zero (0) spacers can
be installed.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 40.
2. Remove the four mounting screws and washers securing the seat adapter plate and
four 3 cm adjustment spacers to the seat base.
3. Perform one of the following:
• To Reduce Seat Height by Three Centimeters - Remove one set of 3 cm adjustment
spacers to achieve desired height.
• To Reduce Seat Height by Five Centimeters - Remove both sets of 3 cm adjustment
spacers to achieve desired height.
4. Perform one of the following:
NOTE: The seat comes installed with four 3 cm spacers secured by 9 cm mounting screws. 4 cm
and 6 cm mounting screws are supplied with the seat.
• For Seat Height Reduced by Three Centimeters i. Align the mounting holes on the seat adapter plate with the mounting holes on
the adjustment spacers and the seat base.
ii. Install the seat adapter to seat base using the 5 cm mounting screws and
existing washers and locknuts (if required). Securely tighten.
• For Seat Height Reduced by Five Centimeters i. Align the mounting holes on the seat adapter plate with the mounting holes on
the adjustment spacers and the seat base.
ii. Install the seat adapter to seat base using the 3 cm mounting screws and
existing washers and locknuts (if required). Securely tighten.
5. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 40.
CAUTION
Spacers should be placed in orientation shown, otherwise they will interfere with
the seat lever.
Pronto® M61™with SureStep®
42
Part No. 1139640