Download User Manual

Appendix A.5
Color Bar Table File Format
67B
For an image window of Single Channel image, the applied Color Bar Table file for the image is shown
on [Color Bar Table] pull down located below [Tool Bar]. Some typical Color Bar Table files are stored in
the color table / look-up table folder. You can edit these files and save your own Color Bar Table. You can
also edit it with a text editor such as WordPad or Notepad.
Parameters
Table A.5-1 Color Bar Table File Format
Format
Descriptions
Title
//character string
The default is "Earth Observation Data Viewer
COLOR TABLE DEFINE"
n is an integer selected from 2, 3, 5 or 9.
Number of Points
N=n
Logarithm Interpolation
LOG_MODE = value
Inserting Color Bar mode
REVERS_MODE
=value
Title Name
TITLE_NAME=[value]
Relation between Data Value VAL = xxxx.x [TAB]
and RGB Color Value at point 1 COLOR = n1, n2, n3
:
:
Relation between Data Value same as above
and RGB Color Value at point
N
value is set "ON" or "OFF".
If it is set as "OFF", Liner Interpolation is applied.
value is set "ON" or "OFF".
If it is set as "ON", the flipped color bar is inserted
into an image file.
Color Bar table name
[TAB] means Tab key.
XXXX.X is a real value.
n1, n2 and n3 are Color Value of red, green and blue
respectively and its value is between 0 and 255.
:
same as above
N is the number of points defined in the above.
// Earth Observation Data Viewer COLOR TABLE DEFINE
N=9
LOG_MODE = OFF
REVERSE_MODE = OFF
TITLE_NAME = [AMSR-E Brightness Temperature [K] ]
VAL = 154.800003 COLOR = 0, 0, 255
VAL = 176.225006 COLOR = 0, 128, 255
VAL = 197.649994 COLOR = 0, 255, 255
VAL = 219.074997 COLOR = 0, 255, 128
U
Figure A.5-1 A Sample of Color Bar Table
A-10