Download Remote User Manual

POINT ADDRESS: When using a point address and the buffer does not touch and/or cross over the street the
work is taking place on as shown in the example below; you must use the “Draw Polygon” tool marking from
the point address to that road work is taking place on. The reason for using the “Draw Polygon” tool is there
may be utilities that run from the road to the site address that would not be notified because the buffer did not
touch and/or cross over the street work is taking place on. It is very important to use your raster on these
tyes of notices so you can view the size of the site. You will need to mark the polygon around the entire site
marking all the way out to the street the work is taking place on.
If you process a point address locate notice and the buffer does not touch and/or cross over the street work is
taking place on once the point tool is selected; the “Draw Polygon” tool must be used. You will need to mark
the polygon around the entire site, marking all the way out to the street the work is taking place on.
24