Download SD7 User Manual Version A - DiGiCo

Chapter 2 - Channel Types
The EQ and dynamics settings can also be safed and unsafed from within the eq and dynamics displays. The whole channel can also be
safed and unsafed by pressing the SAFE button at the bottom of on-screen channel (Offline software). This button also appears towards
the bottom right-hand corner of the channel worksurface controls, labelled full safe. It is grey to indicate that some elements of the
channel are not safed, and red to indicate that the entire channel is safed.
Tip: When some elements of the channel are safed, a double-press on the SAFE button can be used to quickly clear all
channel safes.
Note: Channel safes refer specifically to snapshot recalls and do not protect channel settings when using the copy
from, copy to and presets functions described below.
2.2.4 Channel Settings ..................................................................
The Channel Settings area of the Setup display allow channel settings to be copied between channels. The left and right arrow buttons
are used to move the Setup display to adjacent channels and are also found on the console worksurface..
The copy from button allows settings to be copied from other channels to this channel and those to its right: Pressing copy from opens
up a Copy Channels display:
The extent of the channel settings to be copied is selected using the scope buttons towards the bottom of the display. Each button
lightens to indicate that it is included in the copy function. The number of source channels to be copied is defined either by selecting the
appropriate grey numbered button, or by selecting the keypad button to the right of the numbered buttons, typing the required number of
source channels into the numeric keypad which appears, and pressing OK. Press the LCD button (shown below) on the left-most source
channel in order to action the channel copy. If more than one source channel has been selected, the settings of appropriate number of
channels to the right of the source channel will copy to the channels to the right of the destination channel (The current Assigned channel).
For example, to copy the EQ settings on channels 1-8 to channels 9-16 respectively:
Make channel 9 the Assigned channel and touch copy from
In the scope area of the Copy Channels display, select only the eq button
Set the number of channels to be 8.
Press the LCD button on channel 1.
1-3