Download Owner`s Manual Automatic Standby Generator

DATA LABEL
(SEE SAMPLE)
OIL
DIPSTICK
AIR FILTER
EXHAUST
ENCLOSURE
CONTROL
PANEL
CIRCUIT
BREAKERS
FUEL
INLET
(BACK)
FUEL
REGULATOR
COMPOSITE BASE
OIL FILTER
OIL FILL CAP
BATTERY COMPARTMENT
Figure 2-3: GT-990/GT-999 Engines, 16-22 kW Units
2.2 — Protection Systems
The generator may have to run for long periods of time with no operator present to monitor the engine/generator conditions. Therefore, the generator is equipped with a number of systems to automatically shut down the unit to protect it against potentially damaging conditions. Some of
these systems are as follows
Alarms:
•
High Temperature
•
RPM Sensor Loss
•
Low Oil Pressure
•
Controller Fault
•
Overcrank
•
Wiring Error
•
Overspeed
•
Underspeed
Warnings:
•
Charger Warning
•
Overvoltage
•
Charger Missing AC
•
Undervoltage
•
Low Battery
•
Fuse Problem
•
Exercise Set Error
•
Overload
•
USB Warning
•
Stepper Overcurrent
•
Download Failure
The control panel contains a display which alerts the operator when a fault condition occurs. The above list is not all inclusive. For more information about alarms and control panel operation, see Section 3 Operation.
NOTE: A warning will indicate a condition, on the generator, that should be addressed but not shut the generator down. Am alarm will shut the generator down to protect the system from any damage. In the event of an
alarm, an owner can clear the alarm and restart the generator prior to contacting their independent servicing
dealer. If the intermittent issue occurs again, contact your independent servicing dealer.
6
Automatic Standby Generator Owner’s Manual