Download Inverter Plasma Cutter
Transcript
WK250000AV Operation CUTTING – STARTING A CUT AT EDGE OF WORKPIECE 1. Position the torch tip 1/16 inch (1.6 mm) above the workpiece at the start of the intended cutting path. The tip should be perpendicular to the surface of the metal. See Figure 6. 2. Pull trigger to start the plasma torch flame. 3. Move torch slowly along the intended cutting path. The flame should cleanly cut through the metal. Adjust the hand travel speed faster or slower according to the effectiveness of the cut. Pulling the torch is generally a smoother and more controllable motion than pushing the torch. See Figure 7. 4. The sparks should pass through the workpiece if the sparks reflect back from the surface the hand travel speed is too fast. See Figures 7 and 8. NOTE: The underside of the kerf edges will have dross, which is a build-up of metal and oxides; this is normal. The dross can easily be removed with a disc sander. If the dross is difficult to remove, increase the hand travel speed slightly when cutting. 1/16 inch (1.5mm) Figure 6 90° Preferred Travel Direction Proper cutting speed has sparks coming out the bottom of the workpiece. Figure 7 Hand travel speed is too fast if sparks are reflecting back from the workpiece. Figure 8 www.chpower.com 9