Download Instruction Manual

TANK
5.2.1
EN
CHILLER LINE
Information on the display
On:
unit in cooling mode (Ref. A9 Fig. 12).
On:
unit in heating mode (Rif. B1 Fig. 12).
Flashing light:
unit ready for cooling (Rif. A9 Fig. 12).
Flashing light:
unit ready for heating (Rif. B1 Fig. 12).
5.2.2 Thermostat settings
Refer to figure 12 for buttons detection.
1) To change the temperature of the water:
a. Push the button SET for 3 seconds (Rif. A8), display shows the current value setting, and the unit of
measure icon (C or F ref C3) starts to blinking.
and
(Rif. C2 and A7) (5 ÷ 35°C / 41 ÷ 95°F).
b. Modify the parameters using the arrows
c. Push the button SET (Rif. A8) to confirm the values.
2) To adjust other parameters: hysteresis function (Hy), probe calibration (Ot), except for the heater (O1):
button for 3 seconds (Ref. A7 and A8). The
d. Access to the programming menu by pressing the SET+
icon unit selected starts blinking (C or F ref C3) and appears Hy.
and
(Ref.C2 and A7) until the desired parame. Scroll through the parameters using the arrows
eter.
f. Press the SET button (ref A8), the current set value is displayed.
and
(Rif. C2 and A7).
g. Change the value using the arrows
h. Press the SET button (Ref. A8) to confirm the setting and move to the next parameter.
(Ref. A8 and C2) to exit programming mode.
i. Press SET +
NOTE: If you do not press any buttons for 30 seconds, all settings are saved and the device is
ready for operation.
Parameter
Preset value
Description
Regulation range
Hy
1°C
This parameter sets the hysteresis, that is the
differential of the unit.
0,5 ÷ 10°C
1 ÷ 45°F
Ot
0°C
This parameter adjusts the calibration of the
probe: it allows to compensate for the difference
in temperature reading on the display with respect to the actual water temperature.
-9.9 ÷ 9.9°C
-17 ÷ 17°F
o1
db
Activating / deactivating the heating resistor: Set
on “db” to activate the heater, set to “AL” to turn
off the heater.
db - AL
Tab. 5-2
5.3
TRANSPORTATION AND STORAGE
The chiller must be handled carefully in a vertical position.
It is recommended to place it on a flat surface.
5.4
DEMOLITION AND DISPOSAL
The crossed-out wheelie bin label that can be found on your products, indicates that the product may
not be treated as household waste. By ensuring that this product is disposed of correctly, you will
help preventing potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of these products. For more detailed
information about recycling of this product, please contact your local city office, your household
waste disposal or the dealer where you purchased this product.
This information only applies to customers in the European Union, according to Directive 2002/96/EC of EUROPEAN PARLIAMENT and THE COUNCIL OF 27January 2003 on waste electrical and electronic equipment
(WEEE) and legislation transposing and implementing it info the various notional legal systems. For other countries, please contact your local government to investigate the possibility of recycling your product.
11