Download Red Hat Enterprise Linux 5 Installation Guide

Kapitel 28. Kickstart-Installationen
--driveorder — Specify which drive is first in the BIOS boot order. For example:
bootloader --driveorder=sda,hda
--location= — Specifies where the boot record is written. Valid values are the following:
m br (the default), partition (installs the boot loader on the first sector of the partition
containing the kernel), or none (do not install the boot loader).
--password= — If using GRUB, sets the GRUB boot loader password to the one specified
with this option. T his should be used to restrict access to the GRUB shell, where arbitrary
kernel options can be passed.
--m d5pass= — If using GRUB, similar to --password= except the password should
already be encrypted.
--upgrade — Upgrade the existing boot loader configuration, preserving the old entries.
T his option is only available for upgrades.
clearpart (optional)
Removes partitions from the system, prior to creation of new partitions. By default, no partitions
are removed.
Anmerkung
Wenn der Befehl clearpart verwendet wird, kann der Befehl --onpart bei einer
logischen Partition nicht verwendet werden.
--all — Erases all partitions from the system.
--drives= — Specifies which drives to clear partitions from. For example, the following
clears all the partitions on the first two drives on the primary IDE controller:
clearpart --drives=hda,hdb --all
--initlabel — Initializes the disk label to the default for your architecture (for example
m sdos for x86 and gpt for Itanium). It is useful so that the installation program does not ask
if it should initialize the disk label if installing to a brand new hard drive.
--linux — Erases all Linux partitions.
--none (default) — Do not remove any partitions.
cm dline (optional)
Perform the installation in a completely non-interactive command line mode. Any prompts for
interaction halts the install. T his mode is useful on IBM System z systems with the x3270
console.
device (optional)
On most PCI systems, the installation program autoprobes for Ethernet and SCSI cards
properly. On older systems and some PCI systems, however, kickstart needs a hint to find the
proper devices. T he device command, which tells the installation program to install extra
modules, is in this format:
24 1