Transcript
Aeron Jacket Hanger Installation Guide 1 2 3 3mm 1. Remove screw from clamp using 3mm allen key. 4 2. Open clamp and position centrally on back of Aeron chair. 3. Use Herman Miller logo to align, push clamp over lip. 6 5 3mm 4. Replace screw and tighten to ‘hand tight’ using allen key. 5. Place wire component over clamp. Supports garments upto 5kg. Should not be used for long coats as they may become caught on the chair’s castors. If this occurs, the wire component will disengage, minimising damage to the Jacket. If excessive force is applied to the hanger such as pushing or pulling, the wire component may disengage from the clamp. Re-assemble wire component by following steps 5 & 6. 6. Press outer edges of hanger on both sides until wire component engages into slot in clamp. Herman Miller International Headquarters T +44 845 226 7201 www.hermanmiller.com/europe www.hermanmiller.com/asia www.hermanmiller.com/LAC Herman Miller, and Aeron are registered trademarks of Herman Miller, Inc.
