Download Operating instructions A2E200AH3801

Operating instructions
A2E200-AH38-01
Overtemperature of
motor
Unacceptable
operating point
Ambient temperature
too high
Insufficient cooling
Check operating point
Lower ambient
temperature if possible
Improve cooling
If you have any other problems, contact ebm-papst.
5.1 Cleaning
NOTE
Damage to the device during cleaning.
Malfunction possible
→ Do not clean the device using a water jet or high-pressure
washer.
→ Do not use any cleaners containing acids,
bases or solvents.
→ Do not use any pointed or sharp-edged objects to clean.
Translation of the original operating instructions
5.2 Safety test
What has to
be tested?
Check the
protective
casing against
accidental
contact for
damage and to
ensure that it is
intact
Check the
device for
damage to
blades and
housing
Mounting the
connection lines
Mounting of
protective
earth connection
Check the
insulation of
the wires for
damage
Condensate
discharge
holes for
clogging, as
necessary
Weld seams
for crack
formation
Check the ball
bearings to
ensure they
are quiet, can
move easily
and are free of
play
How to test?
Frequency
Visual inspection At least every
6 months
Which
measure?
Repair or
replacement of
the device
Visual inspection At least every
6 months
Replacement
of the device
Visual inspection At least every
6 months
Visual inspection At least every
6 months
Fasten
Visual inspection At least every
6 months
Replace wires
Visual inspection At least every
6 months
Open bore holes
Visual inspection At least every
6 months
Replace device
Manual check
by turning the
rotor in shut-off
state
Replace
device in case
of noise,
difficulty of
movement or
clearance of
the bearings
At least every
6 months
Fasten
Item no. 10146-5-9970 · Revision 71618 · Release 2008-12-01 · Page 9 / 9
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · [email protected] · www.ebmpapst.com