Transcript
Date 14-11-2013 Page 1 van 1 Installation manual Introduction. To install this Battery Disconnect Switch in a proper way without damage please follow the installation steps as describe hereunder. Content. The package contains the following items: The Battery Disconnect Switch. The executable switch (rocker switch or key switch). An extension cable when ordered. Installation manual Product specification Mounting sequence. 1. Switch off all electrical systems which are direct or indirect connected to the battery. 2. De-mount the original battery terminal from the plus pole of the battery (red) 3. Mount the Battery Disconnect Switch on the plus pole of the battery (A). Be sure that the nut is turned on tight. 4. Connect terminal (B) to the minus pole of the battery. 5. Re-mount the original battery terminal on the cone shaped body (C) of the Battery Disconnect Switch. 6. Connect the executable switch with the connector to the connector (D) of the Battery Disconnect Switch. 7. If applicable, the extension cable to be connected between the connector (D) of the Battery Disconnect Switch and the connector on the executable switch. 8. When applicable electrical consumers connected to stud bolt (E) will NOT be switched off. or