Download New Bigfoot GAP User guide - V-Data

18
3. Registering your
Headset
Prior to using your C70 headset for the
first time, you MUST register(1) it with
your DECT™ telephone.
Before attempting to register the C70
headset, first read the instructions for
registering a new DECT™ handset in
the manual supplied with your DECT™
telephone. The process for registering
the C70 headset will be very similar
and the information below describes
the registration sequence for a typical
DECT™ telephone.
1. Change the system Authentication
code of your DECT™ telephone to
0000 to match the preset PIN of the
C70 headset. Your DECT™ telephone
manual will describe how to do this.
Note: Many DECT™ telephones
already use 0000 as their default
Authentication code, so you may not
need to change it.
2. Place the DECT™ telephone base
in subscription mode by following the
instructions in your DECT™ telephone
manual.
3. Do not follow the DECT™ telephone
manual instructions to place the
handset in registration mode as this
will register the handset rather than
the headset.
Instead, activate headset registration
mode by PRESSING the Mute
Control as if to activate Mute but
HOLDING until the ON-LINE indicator
illuminates.
4. The headset is paired to the base
when the ON-LINE indicator goes
extinguishes.
5. Complete registration by following
any remaining instructions in your
DECT™ telephone manual.
Important: Your DECT™ telephone
system must comply with the Generic
Access Protocol (GAP) standard to
work with the C70 headset. Most
modern DECT™ systems comply with
the GAP specification, but some older
systems may not. If in doubt, check
the documentation supplied with your
DECT™ telephone.
For more information, visit www.
plantronics.com which provides a
list of compatible DECT™ telephone
systems and provides detailed headset
registration instructions for the most
common models of DECT™ telephone.
(1) Registration is sometimes also
referred to as subscription or pairing.
DEABBILDUNGSSCHLÜSSEL
HEADSET
1. Tasten für Hörlautstärke (kurzer
Tastendruck) und Stummschaltung
(langer Tastendruck der LeiserTaste)
2. Annehmen und Beenden von
Gesprächen
3. Gesprächsleuchtanzeige
4. Sprechröhrchen (ausgestattet mit
langer Version)
5. Ersatz-Sprechröhrchen (kurze
Version)
6. Ohrhörer
TISCHLADESTATION
7. Netzladegerät
8. Anschluss für das Netzladegerät
9. Headset-Ladestation
10. Ladekontakte
11. Ladeanzeige
12. Betriebsanzeige
13. Modul der Tischladestation
SO GEHEN SIE VOR
Führen Sie zur Inbetriebnahme Ihres
DECT™-Headset-Systems Plantronics
C70 die folgenden einfachen Schritte
aus: