Download operating instructions bedieningshandleiding

Transcript
FastCheck
It is recommended that the brake pads are replaced with OE equivalent parts. The
DSC module may not recognise a terminal change if using non-genuine brake pads.
Select CBS for vehicles only fitted with a J1962 16 pin connector and support CBS.
Applicable vehicles:
BMW 1 series (E81/E87)
BMW 3 series (E90/E91/E92/E93)
BMW 5 series (E60/E61)
BMW 6 series (E63/E64)
BMW 7 series (E65)
BMW X5 (E70)
BMW X6 (E71)
MINI (R55/R56/R57)
NOTE: Refer to the ‘Vehicle Application List’ to determine the correct cable.
CBS is a system in which the vehicle calculates and monitors the status of serviced
components and fluid levels as well as time and mileage based services.
The following table displays possible service options together with the control
module used to reset each option.
Service option
Control module
Engine oil
Engine (DME/DDE)
Particulate filter
Engine (DDE)
Diesel additive Engine (DDE)
Engine (DDE)
Front brake pads
Dynamic stability control (DSC)
Rear brake pads
Dynamic stability control (DSC)
Micro filter
Climate control (IHKA)
Brake fluid
Instrument cluster (INSTR)
Coolant
Instrument cluster (INSTR)
Spark plugs
Instrument cluster (INSTR)
Vehicle check
Instrument cluster (INSTR)
Statutory vehicle inspection
Instrument cluster (INSTR)
Statutory exhaust emission inspection
Instrument cluster (INSTR)
The service tool will automatically identify all control modules required during the
reset process. If an unknown control module is found or communications cannot be
established, the operator is prompted to either continue or abort.
110