Download Power Switch Internal Installation manual

ICY2042PSI
Power Switch Internal
Installation manual
Intro
The Power Switch Internal
enables you to switch electric
heaters with a room thermostat.
The ICY2042PSI is galvanically
isolated and can be placed in a
conduit box.
Installation
1.
Switch off the power.
2.
8VHWKH¿UVWWZRFRQQHFWRUV
of the top terminal block to
connect the Power Switch
to the 230V mains power.
(see image below).
3.
Connect wiring between the
third and fourth connectors
and the electric heater.
4.
Connect wiring between the
thermostat and the connectors of the bottom terminal
block. There is no need to
observe polarity.
Thermostat
N
L
Low voltage On/Off
230V
Connection diagram
230V
Electric heater.
Set heater to Max.
© I.C.Y. B.V.
[email protected]
www.icy.nl
# 2013-1