Download Alcoa Wheel Service Manual

Transcript
5.m.ii. Section A, how to measure stud standout?
Stud standout is measured from the axle end mounting surface:
• i.e. the hub for disc brake operated axles and inboard mounted drums of drum brake operated axles to the first
complete thread at the outside end of the stud
• i.e. the drum for outboard mounted drums of drum brake operated axles to the first complete thread at the outside end
of the stud
inboard mounted drum
outboard mounted drum
5
1
2
4
5
3
4
1.
2.
3.
4.
5.
6.
hub
exposed shoulder
first full thread
drum
stud standout
mounting surface
5
3
1
6
6
For safe mounting with replacing wheel studs the stud standout must cover:
Single mounting:
For use with 2 piece flange nuts and replacing studs the
minimal stud standout must be:
• 1x disc thickness Alcoa wheel + height of nut + 3 mm
for use with M22, M20 or M18 x 1.5 threads (or 2 full
threads in case of other type of threading such as BSF
or UNF)
• Example 1x 22.5 x 9.00 Alcoa wheel with 22 mm disc
thickness and a regular 2-piece flange nut M22 x 1.5
result in a stud standout of 22 + 27 + 3 = 52 mm
Dual mounting:
For use with 2 piece flange nuts and replacing studs the
minimal stud standout must be:
• 2x disc thickness Alcoa wheel + height of nut + 3 mm
for use with M22, M20 or M18 x 1.5 threads (or 2 full
threads in case of other type of threading such as BSF
or UNF)
• Example 2x 22.5 x 9.00 Alcoa wheels with 22 mm disc
thickness and a regular 2-piece flange nut M22 x 1.5
result in a stud standout of 2x 22 + 27 + 3 = 74 mm
41