Download Operating Instructions

Target Steering
receiver should be placed is approximately 35 ft (10.7 m). Beyond this distance the up/down information
becomes less accurate.
Programming the Receiver for Target Steering
The receiver must be programmed with the desired target depth number. To program the receiver, see
the instructions under “Target Steering Menu” in the Receiver section.
The figure below shows the receiver’s locate screen with the Target Steering distance at the bottom. This
number is the horizontal distance that the receiver is from the transmitter. You will use this number to help
you position the receiver a maximum distance of 35 ft (10.7 m) ahead of the tool.
Horizontal distance
between transmitter
and receiver
Receiver Screen with Target Depth Programmed
Steering to the Target
Once the target depth number has been entered on the receiver and the receiver has been positioned
ahead of the tool as the target, then select remote mode from the remote’s main menu (see “Main Menu”
in the Remote Display section). You will then see the Target Steering screen shown below.
Steering
indicator
Center of
crosshairs
Transmitter roll
Horizontal distance
between transmitter
and receiver
Approximate
transmitter depth
®
®
DigiTrak F2 Operator’s Manual
75