Download INSTALLATION MANUAL OEM-VW COMMAND MODULE IN

INSTALLATION MANUAL OEM-VW COMMAND MODULE
IN COMBINATION WITH AN AP300-AP500
2
6
3
7
OEM Command module
connector Audi/VW (Back
side Command Module
AP300-AP500 Command
module connector
1.
KEYBOARD INITIALIZATION MODE OPERATION
The keyboard initialization mode is only required if you change the command module keyboard
from the factory supplied unit or wish to change the factory default accel command from the default
SET/ACCEL to SET/DECEL.
To enter the Keyboard Initialization Mode, press and hold the S1(blue button) key located on the
Electronics Module PC Board for 4 seconds. The Electronics module will respond with 5 Hi tone
beeps.
Press the RES button on the command module to instruct the cruise control to operate in the
SET/DECEL mode. The Electronics module will respond with 2 low tone beeps and exit the
Keyboard Initialization mode.
SW1
LED
ECU AP300-AP500