Transcript
User Manual - FLASHING BADGE - Timer Version: EAN Nr. 4 260284 190187 - Solar Version: EAN Nr. 4 260284 190194 Thank you for choosing our FLASHING BADGE. FLASHING BADGE is designed as promotion product and patent registered. It can be used indoors as well as outdoors. It is not waterproof. Do NOT use it in the rain or snow. FLASH BADGE is especially helpful as follows: 1. 2. 3. Used as a badge. Name or ID card changeable. Hanged by a lanyard as accessory available. Used as a torch. Turn on the light by pressing the built-in button and the light can be kept by hold pressing the button. The light shall be turned off automatically by releasing the button. By the Timer version: Integrated timer for 15s light holding. Turn on the light by pressing the built-in button and the light will be held for 15s. After that the light turned off automatically. By the Solar version: Used as a signal sender (e.g. SOS) manually controlled by built-in button. Integrated a Solar Module for environmental- friendly charging by sunlight. Attention Please read the user manual carefully before using the product! The user manual is one part of the product. It includes important instructions for the usage and disposal of product. Always keep the user manual for reference! It must be transferred to third persons together by handing out the product. Safety Instructions The warranty is invalid if the damages are caused without your reading this manual in advance. We are not liable to the damages inclusive property damage or personal injury which is caused by not following the safety instructions or improper use of the product. Do not look directly into the LED light beam. Do not point the LED light beam directly at the eyes of the other people and animals. Please note that the LED light beam is highly strong which could hurt eyes and bring blinding effect and disturb the moving traffic. Generals The product is tool which is not a toy! Keep the product away from children. Store the product dry. Avoid heavy shocks or heating. Warning – Batteries Timer Version: 2pcs x CR1220, total 6V (replaceable) Solar Version: 1pc x LIR-2032 3.6V rechargeable for 500 times Batteries are excluded from warranty. By Timer Version the used batteries can be replaced by 2 pieces batteries in the-Type of CR-1220. Insert the batteries correctly and make sure the correct polarity (+ / -). Do not open, swallow, recharge batteries and keep batteries away from water, fire or high temperatures. Batteries may explode or leak, and cause damage. Keep away from children ! Batteries do not belong in the normal household trash! Please dispose them at an official collection! Turn On and Off Take the flashing badge between thumb and forefinger. Press the circle icon with your thumb. The LEDs light as long as the circle icon is pressed. By Timer Version: Just one press then the light will last for 15 seconds Specifications Dimension (LxWxH in mm): 88x58x4 (Hmax: 8.5mm) for paper cards in standard name card size: 85 x 55 mm, ideal paper weight: 260-300 g/m2 Weight: Timer version around 21g / Solar Version around 18g without name card LED Number: Timer version in 2 LEDs / Solar version in 3 LEDs LED use life: 50 000 hours. Product color: White (Standard), Customization available Warranty: 3 years - exclusive battery Extra Accessories: Packing Box, Hanging lanyard - if ordered Disposal Please dispose the FLASHING BADGE after useful life environmental friendly in the local return and collection system. Gehrs Marketing GmbH, Spinnereistr. 6, 35576 Wetzlar, Germany Servicekontakt: [email protected] Hotline: +49 6441 9027-0 www.cardlight.de