Download Operating Instructions Air Conditioner
Transcript
PRODUCT OVERVIEW ■ About Remote Control Preparation Air intake Indoor Indoor Unit Unit 1. Pull out the cover. Supersonic air purifying device Auto OFF/ON button Front panel 2. Insert AAA or R03 batteries. 4. Press CLOCK. 5. Press to set time. TIMER ON Indicator S SET 1 2 OFF FF Airflow direction louver 3 CANCEL AC SET Receiver Air filter 3. Close the cover. CLO CHECK CLOCK RC Ionizer RESET Discharged air 6. Press again. Do not touch during operation Outdoor Outdoor Unit Unit • Timer operation will be based on current time set. Air inlet (rear) • The batteries can be used for approximately 1 year. Air inlet (side) Remote Control Signal • Make sure it is not obstructed. • Maximum distances: 10m • Certain fluorescent lights may interfere signal transmission. Please consult your nearest dealer. Air outlet Remote Remote Control Control Auto OFF/ON Button Action Press once. Transmitter Mode Automatic AUTO HEAT COOL DRY LCD display Press and hold until you hear one beep, Cooling then release. FAN SPEED AIR SWING ION Operation mode Quiet Operation Powerful Operation Press and hold until you hear one beep, then release. Heating Press and hold until you hear two beeps, then release. MODE Ion operation OFF/ON ion Temperature setting QUIET POWERFUL Airflow direction adjustment TIMER ON Off/On TEMP FAN SPEE D Fan Speed selection AIR SWING SET 1 Check • To turn off, press the AUTO OFF/ ON button again. 2 OFF 3 CANCEL AC SET CHECK CLOCK RC Timer setting Clock setting RESET INVERTER * For normal operation, the and reset buttons are not in use. * Press reset to restore the remote control’s default setting. Troubleshooting ● In the event of an error, the unit will stop and the timer indicator will blink. 2. Press until you hear beep sound, then jot down the error code. 1. Press for 5 seconds. TIMER ON 1 SET 2 F OFF 3 C CANCEL AC SET 4 CHECK CLOCK 3. Press for 5 seconds to quit checking. RC RESET 4. Turn the unit off and reveal the error code to your nearest dealer. Notes: • The unit may be operable (with 4 beeps) on a limited basis, depending on the error.