Download Control Unit SG-RSV 2X9 Operating Instructions

Page /6
Installation and Operation
Installation
The enclosure of the control unit can be
mounted in any position:
- on a 35 mm standard rail EN 50022
Wiring is connected to the cable clamps
of the plug connections:
WARNING!
Do not release terminals or connect
plug connections with power on.
Sensor 1 Y1Y2
Sensor 2 Y3Y4
Supply voltage A1A2
Relay “fault” 13 14
Relay “activated” 23 24
Relay “monitoring loop” 33 34
Internal train signal "Door closed"TG
Internal train signal "Door release"TF
Internal train signal "Move command"FB
Internal train
signal
"Door closed"
Internal train
signal
"Door release"
Internal train
signal
"Move command"
Sensor X
activated
Relay "Activated"
de-energised
Activation
no
yes
Normal mode
Us
yes
no
tA: 2-15 s
Us
yes
no
yes
no
Sensor not activated
- relay “activated” is energised
- relay “fault” is energised
- relay “monitoring loop” is energised
(depending on internal train signals)
no
yes
tD: 0,1-2,5 s
Fault signals
Operating
voltage
Fault channel X
Fault internal
yes
no
<10ms
>500ms
Fault
lock
Fault
lock
Self-test
>10ms
Relay "Fault"
de-energised
no
yes
250609 v2.5
Self-test
Relay "Monitoring no
loop"
yes
de-energised
Sensor activated
- LED "Betätigt Kanal X" (activated
channel X) lights up
- relay “activated” is de-energised
- relay “monitoring loop” is
de-energised (depending on internal
train signals)
Sensor disconnected
- LED "Störung Kanal X" (fault channel
X) lights up
- relay “fault” is de-energised
- relay “monitoring loop” is
de-energised
yes
no
yes
no
After connecting up sensors, relay contacts and power, carry out a function
test in the following order:
Basic settings
Two times can be varied on the unit:
- Active time tA: factory setting 2 s,
8 s or 12 s
- Extension time tD: factory setting
200 ms
Us
Relay "Monitoring no
loop"
yes
de-energised
tN: 200 ms
Commissioning
Self-test
Note:
Restart normal operation by changing
the internal train signals "Door closed"
and/or "Door release".
Mayser Polymer Electric Postfach 30 48 89020 Ulm GERMANY Tel. +49 731 2061-0 Fax +49 731 2061-222