Download Scotch 105 Use and Care Manual
Transcript
A ly Decorative Project: Window Decorations Add some of your personality to your windows! Materials needed: • 8 sheets of tag board (2 of each color) • 1 roll cellophane wrap • 1 package Mylar wrapping paper • 1 can 3M Super 77 Spray Adhesive • 1 roll colored string (coordinated to tag board colors) • 1 can high gloss spray paint (optional) • 1 pair Scotch™ Precision Ultra Edge Non-stick Scissors • Pencil and circular objects for tracing • Ruler • Scotch® Magic™ Tape • 6 Command™ Clear Small Hook Steps: Trace 3” circles onto each sheet of tag board. Trace a slightly smaller diameter circle inside of each to create a donut outline. Cut out each circle of tag board and the inner circles. You will have 18 disks of each color and 18 donuts in each color. Using the tag board disk as your guide, trace and cut 18 disks of cellophane wrap and 18 disks of Mylar paper. Be sure to allow an extra ¼” diameter in these disks so they will overlap the inner space of your tag board donuts. Cut 30, 9” lengths of string. Project steps continued --> 3M and Command are trademarks of 3M. © 3M 2012. All rights reserved. A ly Decorative Project: Steps (continued): In a well-ventilated, masked off area, spray one side of a tag board donut. Move the donut to a clean sheet of paper and center the Mylar disk over the donut. Place and press to secure the bond. Place the tip of a length of string onto the edge of the adhesive-sprayed donut. Repeat step 7, linking each tag board unit to another using the lengths of string. Assemble 5 tag board units per strand. You should end with 6 strands, with some extra left over. Be sure to alternate Mylar and cellophane wrap and alternate tag board colors to create a pleasing pattern. Use Scotch® Magic™ Tape to attach the tag board disks to the center of each length of string between every two units. Use Scotch® Magic™ Tape to attach the final 6 pieces of string in loops to the top tag board unit on each strand. Affix 6 Command™ Clear Small Hooks (following all package instructions) to tops of window frames. Hang each strand on the hooks. Enjoy! 3M and Command are trademarks of 3M. © 3M 2012. All rights reserved. Center a second tag board donut on top of the prepared string/Mylar/tag board unit and press to secure the bond.