Transcript
ASSEMBLY INSTRUCTIONS ITEM # heavy-duty DIMENSIONS garment rack IMPORTANT! Plead read prior to use. This chrome garment rack is designed for indoor use. Please do not over-load. To prevent tipping, we recommend that you evenly distribute the weight throughout the unit. (QTY) DESCRIPTION PART GAR-01506 35.12-59.37 in H x 21 in W x 51.12-66.25 in D (66 cm H x 66 cm W x 15.2 cm D) Please do not use garment rack for anything other than its intended use. Please do not allow children, spouses or pets to hang from or hide in storage closet. Please keep away from heat sources such as heaters and fireplaces. ILLUSTRATION (2) side components D (2) horizontal poles (2) vertical poles (1) expanding hanging pole (1) shelf adjustment hole (4) casters F (4) screws G (1) hex wrench H (1) wrench I INSTRUCTIONS Thank you for purchasing our chrome garment rack. Please follow these step-by-step instructions. Please plan to spend about 10 minutes assembling your new garment rack. 1. Position the side components (A) so that the adjustment holes are facing each other. Attach the horizontal poles (B) to the side components (A) by running screws (H) through the side components (A) and into the horizontal poles (B). Tighten with the hex wrench (J). 2. Turn the unit on its side. Screw the casters (G) into the threaded holes on the bottoms of the side components (A). Tighten with the wrench (J). Return the unit to an upright position. G 3. Press the spring pins on the vertical poles (C) and slide the ends into the side components (A) until the spring pins pop through the upper adjusting holes on the side components (A). To adjust the height of the rack, press both spring pins and raise or lower the vertical poles (C) until the spring pins pop through the holes at the desired height. Fit the expanding hanging pole (D) onto the vertical poles. 4. Place the shelf (E) onto the base of the garment rack. H I J G For assistance, please contact us at [email protected] or 877.2.I.Can.Do. LIMITED LIFETIME WARRANTY This product is warranted to be free of defects in material and workmanship for as long as the consumer owns the product. At Honey-Can-Do’s option, defective product will be repaired, replaced or substituted with a product of equal value. For warranty service, e-mail Honey-Can-Do at [email protected] or call at (877) 242-2636. You may also contact Honey-Can-Do at 5750 McDermott Drive, Berkeley, IL 60163. Do not dispose of the defective item until or unless honey-can-do international you are specifically asked to do so by Honey-Can-Do as we may require return of the defective item. Honey-Can-Do shall in no event be liable for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have additional rights, which may vary from state to state. 5750 McDermott Drive, Berkeley, IL 60163 USA tele 877.242.2636 www.honeycando.com ©2013 honey-can-do international, llc | all rights reserved - 121226
