Download Hitch Haul HFTB Instructions / Assembly

Distributed By:
Masterbuilt Outdoor Products
1 Masterbuilt Ct.
Columbus, Georgia 31907
Customer Service 1-800-489-1581
Manual Code: 988050008
091123-10JM
HITCH-HAUL® HFTB FOLDING TOW BAR
ASSEMBLY, OPERATION & SAFETY INSTRUCTION
FOR MODEL: HFTB
Designed for 2” Receivers and Hitch Accessories ONLY
Tools needed for assembly: Two 15/16” wrenches
Not for use with HITCH-HAUL® Wide Cargo Carrier (30110109) with 6” sides
WARNINGS
• Never exceed receiver hitch manufacturer’s tongue
weight rating.
• 500 lbs maximum cargo capacity for the 2” receiver
bar.
• HFTB has a maximum tow weight of 5000 lbs.
• HFTB has a maximum tongue weight rating of 500 lbs.
• Check all hardware connections before each use.
• Check for clearance between your vehicle and hitch
accessories to prevent damage to either.
PARTS AND HARDWARE LIST
1
A
B
C
D
WARRANTY INFORMATION
Parts:
1. Folding Tow Bar
Hardware:
A. Clevis Pin
B. Hitch Pin Clip
C. Bolt
D. Locking Nut
MASTERBUILT Mfg., Inc. warrants all parts of this HITCH-HAUL®
Folding Tow Bar product to be free from defects in material and
workmanship within one year from date of purchase. Within this
period, MASTERBUILT Mfg., Inc. shall correct any defect by repairing
or replacing defective parts of the equipment, or making available
parts thereof, FOB Columbus, GA.
MASTERBUILT Mfg., Inc. shall not be obligated to repair or replace
equipment which has been repaired by others, abused, altered or
misused. We further state that we shall not be held liable for any
losses due to neglectful use on the part of the operator. Upon
expiration of such warranty, all liability shall terminate. No other
warranties are expressed or implied.
ASSEMBLY INSTRUCTIONS
STEP 1
Place folding tow bar (1) into
receiver hitch and secure with
receiver hitch’s clevis pin and hitch
pin clip. Clevis pin for receiver
hitch is NOT included.
STEP 2
NOTE:
Paint finish will scratch and chip under normal use, and
therefore carries no warranty.
1
COMPLETE & RETURN TO
Slide assembled hitch-haul or other
accessory item’s receiver tube into folding
tow bar aligning hole in receiver tube
with front hole of hitch accessory.
ATTN: WARRANTY REGISTRATION
Masterbuilt Outdoor Products
Secure with bolt (C) and locking nut (D).
Tighten using two 15/16” wrenches.
Using both wrenches will help and it’s
IMPORTANT to tighten completely.
1 Masterbuilt Ct. Columbus, GA 31907
Name:
Address:
Lock in place using
clevis pin (A) and
hitch clip (B).
City, State/Province, Postal Code:
B
D
A
Phone Number:
E-Mail Address:
Model Number:
Serial Number:
Purchase Date:
Place of Purchase:
C
NOTE: Clevis pin (A) and hitch pin clip (B)
supplied with accessory are to be installed
when hitch-haul is in a down or upright
position. This prevents it from bouncing up
and down while in use.
STOP!
For Assembly Assistance, Missing or Damaged Parts Call:
MASTERBUILT Customer Service at 1-800-489-1581
DO NOT RETURN TO RETAILER