Transcript
R www.johnsonhardware.com 1575 PPK3 POCKET DOOR FRAME FOR USE WITH JOHNSON 1500 SERIES POCKET DOOR FRAMES ONLY ADAPTER KIT FOR 1/34" THICK DOORS SPACER SPACER SPACER SPLIT STUD SPACER SPACER SPLIT STUDS PINS Discard standard Floor Brackets and replace with 1-3/4" (44mm) Floor Brackets. Before assembling Split Studs to header, snap nylon space pads onto top end of each stud. (Small pins fit into nailer slots and hold spacers in place). Nail studs into place as instructed in 1500 assembly instructons. 1-3/4" (44.5mm) 1-3/8" (35mm) R www.johnsonhardware.com #150 POCKET DOOR EDGE PULL Place door on edge and brace firmly. 1-1/8" (28.6mm) DOOR 1/2" (12.5mm) DRILL 3/4" (19mm) DEEP MINIMUM CLEAN OUT WITH CHISEL 13/16" (20.6mm) 3-1/2" (89mm) [915mm] from bottom. Use template two 1/2" [12.5mm] holes at least 3/4" 1-15/16" (49.2mm) 36" (914mm) FROM DOOR BOTTOM Drop Edge Pull into slot. Make sure Mark around edge of face plate with [2.4mm] deep around inside edge of screws provided. 5/8" (15.9mm) X 3/32" (2.4mm) DEEP 1531/5500 PLBG L.E. JOHNSON PRODUCTS, INC. - 2100 STERLING AVE. - ELKHART, IN 46516 USA- (574) 293-5664 Rev 2/09
