Download Schon 67622-5001 Installation Guide

Installation (continued)
the mixer to the
3 Screwing
standpipe
4 Securing the standpipe
NOTE: Do not to reverse the cold and hot supply.
□
Screw the standpipe (D) onto the mixer (C) by
hand. Turn in a clockwise direction until it is
tight.
□
Locate the assembly on the desired location with
the flexible tails (1) through the prepared hole
and then holding the escutcheon (E), secure the
standpipe (D).
□
If mounting into wooden floor, secure the
standpipe (D) using screws (F) only (wall plugs
are not needed). If mounting into solid floor,
mark the position of holes first and then secure
the standpipe (D) using anchors (G) and screws
(F). Where requried ensure correct anchors for
your floor type are used.
C
Front
D
E
D
F
Cold inlet
supply line
Hot inlet
supply line
G
1
5
www.schonsimplymodern.com
Please contact (800) 880-8164 for further assistance.