Transcript
WARNING: Do not install near Flammable Material. CAUTION: Risk of Fire, Electric Shock or Injury to Persons 1. Turn off power and install in accordance with local electrical codes. 2. Thread lampholders into cover; coat threads with sealing compound (not included) and tighten. 3. Aim lampholder(s) to desired angle and tighten nut(s) on ball joint(s). 4. Wire the lampholder(s) to the supply lines in the box, white to white (neutral), black to black (hot) and green to green (ground). 5. Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb. 6. Use only with a 75 watt or lower bulb. 7. Do not touch hot lens, bezel or enclosure. 8. Close all unused holes with closure plugs. 9. Seal all openings to comply with wet location installation. 10.Use a caulking compound to provide a water tight seal between the luminaire and the mounting surface. Save these important safety instructions Lighted lamp is HOT. CAUTION: Risk of Fire, Electric Shock or Injury to Persons 1. Disconnect power and allow to cool before replacing bulb. Bulb gets HOT quickly! 2. Do not touch hot lens, guard, or enclosure. 3. Do not remain in light if skin feels warm. 4. Do not look directly at lighted lamp. 5. Keep lamp away from materials that may burn. 6. Use only with a 75 watt (type 4) or smaller bulb. 7. Do not touch the bulb at any time. Use a soft cloth. Oil from skin may damage bulb. 8. Do not operate the product with a missing or damaged bezel, lens or gasket. 9. For outdoor use only. Metal Halogen Swivel Lampholder • Includes 75W GY 8.6 Type 4 Bulb Portalámpara Giratoria de Halógena de Metal • Incluye bombilla halogena de 75W NEC & NEMA 3R Compliant LHS100S Hubbell Electrical Products A Division of Hubbell Incorporated (Delaware) 480-921-7552 www.hubbell-bell.com Made in China / Hecho en China Instructions Inside / Instrucciones Adentro United States and Foreign Patents Pending Estados Unidos y patentes Extranjeras Pendientes LHS100_CS_REV-M Gray / Gris
