Transcript
Installation: Add glue to the inside of the trim and slide the U-shaped up from the bottom of the rail. Glue the top trim piece to complete. Optional: If using a cap rail, you may need to cut the rail trim to length. To do this we recommend that you place the trim over a 2x4 DeckoRail bracket for a Notes: DRAWIN Fabrication and material specs for product provided by UFP plant #200. guide and additional strength while cutting with a hand saw. UNLESS OTHERWISE SPECIFIED: No structural analysis or load testing has been performed on this product. The determination of appropriate use conditions remains the responsibility of the end user/contractor. Fastening schedule by end user/contractor. Design specifications provided by contractor. Determining the appropriate shoring necessary to secure and brace this form is the responsibility of the end user/contractor. DIMENSIONS ARE IN INCHES TOLERANCES: FRACTIONAL ANGULAR: MACH BEND TWO PLACE DECIMAL THREE PLACE DECIMAL DRAWN LAST REV. NAME DATE PJB 1/10/2014 1 ENG APPR. TITLE: Bracket Sleeve This brochure is for illustration purposes only. Use of this product must be in accordance with all local zoning and/or building codes. SIZE Job No. 70219 Copyright 2013, Universal Forest Products, Inc. Wood A Dwg. Consumer assumes all risks and liability associated with the use Natural No. xxx SCALE: 1:4 of this product. For details onFiles\ safe handling, go to UFPI.com/ptinfo. J:\GR_Engineering\70001-80000\70001-70500\70219\Solidworks Warrantor does not provide any warranty, either express or implied, and shall not be liable for any damages, including consequential damages. MFG APPR. INTERPRET GEOMETRIC TOLERANCING PER: MATERIAL PROPRIETARY AND CONFIDENTIAL THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF UFP. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF UFP WESTERN DIVISION, INC. IS PROHIBITED. FINISH DO NOT SCALE DRAWING UFP Western Division, Inc. WWW.UFPI.com Instalación: Coloca pegamento en la parte interior de la sección en forma de U de la moldura de madera y deslízala hacia arriba, cubriendo el soporte. Coloca pegamento en la pieza superior de la moldura y colócala en la parte superior para completar la instalación. Opcional: Si usas un pasamanos, tal vez necesites cortar la moldura de baranda a la medida. Para hacer esto, recomendamos que coloques la moldura sobre un soporte DeckoRail de 2x4 para usarlo como guía y para mayor firmeza al cortar con una sierra manual. Este folleto sólo tiene fines ilustrativos. El uso de este producto debe estar en conformidad con todos los códigos locales de zonificación y/o construcción. El consumidor asume todos los riesgos y responsabilidades asociados al uso de este producto. Para obtener más información de seguridad acerca de la manipulación de este producto, visite UFPI.com/ptinfo. El garante no ofrece garantía alguna, explícita o implícita, y no será responsable por daño alguno, incluidos los daños indirectos. 7449_1/14 SHEE