Transcript
Thule System Kit 2018 SATURN Coupé, 97– MAX LOAD 75 Kg Before the load carrier can be fitted, tensioning attachments must first be mounted. The tensioning attachments should always be left on the vehicle (The load carrier should be removed when not in use). Read through these instructions carefully before starting the work of assembly. If you feel in any doubt about how to proceed, ask your local Thule dealer for advice. You will need a TORX tool, number 15, for assembly. x4 6,5 Kg 600 mm 150 mm Press the tensioning attachment onto the moulding. The rearmost attachment must be pressed on and then slid back to the correct position. Open the doors. Remove the plastic cover behind the door. Unscrew the TORX screw (1 off) using TORX tool 15 and remove the cover. Unscrew the 6 TORX screws which keep the plastic moulding in place. Bend the moulding out a bit as shown in the picture. Re-fit the moulding and the plastic cover. 940 mm / 37 inch mm/inch 90 x4 29 x4 Hook the brackets into place in the tensioning attachments. 746•3DFK /501-2018-02
