Download Sharp 26GD4U User's Manual

Transcript
Watching TV
C.
Connecting Antenna Cable with VCR
signal splitter
(commercially
available)
Coaxial Antenna Cable
(commercially available)
Cable lead-in
RF Cable (Supplied)
Audio Cable (commercially available)
Video Cable (commercially available)
VIDEO AUDIO
OUT
IN
VCR
NOTE
• Be sure to remember what kind of connection is made with your System.
• Shown here is the preferred method of connecting a VCR to your TV if you are in an area with good signal reception. This
way you can view either TV programs or VCR tapes and not be concerned about the position of the VCR’s TV/VCR switch
and you can enjoy stereo tape playback from stereo VCR.
• If your lead cable is a 300-ohm twin-lead cable or UHF/VHF separate cable, use a 300/75-ohm adapter or combiner
(output side is 75-ohm coaxial) to connect to the TV (see below).
Outdoor antenna connection
Connecting Antenna Cable
Cable without a CATV
converter
CombinationCable TV lead-In
VHF/UHF antenna
Home Antenna
terminal (75-ohm)
Coaxial cable
(commercially
available)
or 75-ohm coaxial cable (round)
300-ohm twin-lead (flat)
Separate VHF/UHF
antenna
300/75-ohm adapter
(commercially available)
VHF
UHF
ANTENNA ANTENNA
300-ohm
twin-lead
300-ohm twin-lead
Combiner
(commercially
available)
IN OUT
or
75-ohm coaxial cable
RF Cable (Supplied)
NOTICE
F-type connector
75-ohm coaxial cable
F-type connector should be finger-tightened only.
When connecting the RF cable to the TV set, do not tighten
F-type connector with tools.
If tools are used, it may cause damage to your TV set.
(The breaking of internal circuit, etc.)
19