Download Powermate PC0433500 User's Manual

PORTABILITY KIT INSTALLATION
TOOLS REQUIRED: 7/16”, 1/2” and 9/16" sockets and ratchets, block(s) of wood (minimum of 6” tall).
Refer to the parts list and drawing on pages 8 and 9.
WHEEL INSTALLATION
1. Block up end of generator opposite the fuel tank cap to install wheel kit.
2. Insert wheel spacer (item 43) into the center of the wheel (item 35).
3. Slide 3/8 x 4.25” bolt (item 41) and 3/8 washer (item 38) through the wheel (item 35), then through the wheel bracket on the
carrier, with the offset side of the wheel hub against the wheel bracket.
4. Thread 3/8 nyloc nut (item 42) onto the bolt and tighten to securely clamp the wheel assembly to the carrier.
5. Repeat above instructions for the remaining wheel.
FOOT INSTALLATION
1. Assemble the rubber feet (item 37) to the foot bracket (item 50) using a 1/4-20 x 1.5” bolt (item 48). Thread a 1/4 washer
(item 49) and a 1/4 nyloc nut (item 13) to the bolt to secure the assembly. Caution: Do not over tighten so that the foot
material collapses.
2. Blocking up the alternator side of the generator, place the foot bracket under the carrier channel. Thread a 5/16-18 x 1” bolt
(item 36) through the mounting holes and thread a 5/16 flange nut (item 15) to the bolt to secure the foot bracket to the carrier.
LOCKING HANDLE
1. Attach the lanyard (item 39) to the release pin
(item 44) and carrier as shown in the illustration.
2. To lock the handle (item 31) in the extended
position, align the holes in the handle bracket
with the holes in the carrier bracket and insert
the release pin (item 44).
3. Insert caps (item 45) into ends of handle
(item 31)
English
1
2
3
PARTS DRAWING / SCHEMA DES PIÈCES / DIAGRAMA DE PIEZAS
8
PARTS LIST / LISTE DES PIÈCES / LISTA DE PIEZAS
REF. PART
NO. NO.
DESCRIPTION
1
2
3
4
5
6
6A
6B
7
8
9
10
0064921
Note A
0051094
0064949
0000901.01
0065672
0063998
0063999
0065132
0050608
Note B
0065133
Carrier, assembly
Engine Robin EX21 OHC
Isolator
Adapter, engine
Bolt whz 5/16-24 x .63
Stator 3.5 KW 60 HZ
Connector, stator
Connector hsg set panel
Rotor 3.5 KW
Bolt, hex 5/16-24 x 7.75
Washer, lock 5/16
Endbell Wired
10A
10B
11
12
13
14
15
16
17
18
19
20
21
22
23
24
24A
25
26
27
27A
27B
27C
27D
27E
27F
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
0065134
0062745
0065153
0008854
0040832
Note B
0057254
0048736
0064027
Note B
Note B
0047796
0064993
0062566
Note B
0065667
0065669
0062462
0063975
Note C
0061817
0061942
0061816
0061811
0061876
0061875
Note B
Note B
0063164
0064934
Note B
0061393
0049743
0063771
Note B
0055894
Note B
0062174
0064138
Note B
0057578
0062433
0062502
0058955
0007767
0001537
Note B
Note B
0063976
0055982.01
0038984
Capacitor
Brush Cover
Bolt, HWH 1/4-20 x 5.50
Lug, ground
Nut, nyloc 1/4-20
Bolt, 5/16-18 x 1 1/4
Nut, hex flg 5/16-18
Nut, nyloc 5/16-18
Assembly, ground wire
Washer, star external 5/16
Bolt, hex 5/16-18 x 3/4
Spacer .38 ID
Muffler
Gasket
Bolt, 5/16-18 x 1 1/2
Panel, wired
Circuit Breaker 15 amp dual
Screw #6-20 x .38 Type B
Shield, heat
Fuel tank assembly
Fuel Gauge/Screws
Strainer Basket
Fuel Cap
Fuel Shut Off
Filter, fuel valve and washer
Nut, fuel valve
Bolt, 1/4-20 x 1
Washer, flat 5/16
Spacer, handle bracket
Handle
Bolt, 5/16-18 x 2
Nut whz 8mm
Isolator
Wheel
Bolt, 5/16-18 x 1.00
Foot rubber
Washer, flat 3/8
Lanyard
Screw, #10 x .75
Bolt, 3/8-16 x 4.25
Nut, nyloc 3/8-16
Spacer .38 ID
Pin, release
Cap, plastic
Assembly, ground wire
Screw HSW #8 x .38
Bolt, 1/4-20 x 1.50
Washer, flat 1/4
Bracket, foot
Cord Keeper TM
Screen, spark
DESCRIPTION
Ensemble transport
Moteur
Sectionneur
Adaptateur pour moteur
Boulon
Stator
Jeu pr logemt prise, stator
Jeu pr logemt prise, tableau
Rotor
Boulon
Contre-écrou 5/16
Couvre-enroulement, câblage complet
tableau
Capaciteur
Couvre-balais
Boulon
Oeillet de mise à la terre
Écrous nyloc 1/4-20
Boulon
Écrous 5/16-18
Écrous nyloc 5/16-18
Ensemble fil de mise à la terre
Rondelle à dents externa 5/16
Boulon, tête hex 5/16-18 x 3/4
Entretoise
Silencieux
Joint
Boulon
Tableau compl. câblé
Disjoncteurs 15 amp
Vis
Écran de chaleur
Ensemble complet du réservoir
Combustible Indicador/Tornillos
Passoire Panier
Capuchon
Fermeture d’essence
Filtre et rondelles
Écrous
Boulon
Rondelle plates 5/16
Entretoise
Poignée
Boulon
Écrous
Sectionneur
Roue
Boulon
Pied
Rondelle plates 3/8
Lanyard
Vis
Boulon
Écrous nyloc 3/8-16
Entretoise
Epingle de relâchement
Capuchon
Ensemble fil de mise à la terre
Vis
Boulon
Rondelle plates 1/4
Support de pied
Cord KeeperTM
Crépine
DESCRIPCIÓN
Transportador, conjunto
Motor
Aislador
Adaptador, motor
Perno
Estator
Conjunto de conectores stator
Conjunto de conectores panel
Rotor
Perno
Arandela, de cierre 5/16
Caja posterior con cable
Capacitor
Cubierta de escobillas
Perno
Terminal, tierra
Tuerca, nyloc 1/4-20
Perno
Tuerca, 5/16-18
Tuerca, nyloc 5/16-18
Conjunto, câble de tierra
Arandela, estrella
Perno
Espaciador
Silenciador
Empaquetadura
Perno
Panel, cabeado completo
Cortacircuitos 15 amp
Tornillo
Pantalla para el calor
Conjunto tanque
Essence Écartement/Visser
Colador Canasta
Tapa de combustible
Apagado combustible
Filtro y arandela
Tuerca
Perno
Arandela, plana 5/16
Espaciador
Manija
Perno
Tuerca
Aislador
Rueda
Perno
Pie
Arandela, plana 3/8
Acollador
Tornillo
Perno
Tuerca, nyloc 3/8-16
Espaciador
Alfileres de la liberación
Tapa
Conjunto, câble de tierra
Tornillo
Perno
Arandela, plana 1/4
Soporte del pie
Cord Keeper TM
Malla
QTY
1
1
2
1
4
1
1
1
1
1
3
1
1
1
4
1
10
1
7
2
1
2
2
1
1
1
2
1
1
4
1
1
1
1
1
1
1
1
4
1
1
1
1
2
1
2
2
2
2
1
2
2
2
2
1
2
1
4
2
6
1
2
1
9