Download Peerless Industrial Group Industrial Group Stud Sensor ACC 215 User's Manual
Transcript
Assembly Instructions - Metal Stud Fastener Kits Models: ACC 215, ACC 415, ACC 615 Parts List Description A B C Qty. Part No. toggler (ACC 215 only) 2 560-9708 toggler (ACC 415 only) 4 560-9708 toggler (ACC 615 only) 6 560-9708 1/4-20 x 2.5" phillips (ACC 215 only) 2 520-9521 1/4-20 x 2.5" phillips (ACC 415 only) 4 520-9521 1/4-20 x 2.5" phillips (ACC 615 only) 6 520-9521 1/4" SAE washer (ACC 615 only) 6 540-9440 A B C 1 of 2 Visit the Peerless Web Site at www.peerlessindustries.com ISSUED: 05-23-02 SHEET #: 120-9012-4 10-29-07 For customer service call 1-800-729-0307 or 708-865-8870. FOR METAL STUD WALLS ONLY: Drill four 1/2" (13mm) dia. holes through drywall and studs at locations corresponding to wall plate. Insert togglers (A) as shown below... WARNING • Product must be mounted through drywall that has a minimum thickness of 1/2" and into metal studs, 26 gauge or heavier. A • Make sure that togglers are anchored into the center of the studs as shown in figure 1. The use of an "edge to edge" stud finder is highly recommended. ∅ 1/2" (13 mm) Pivot end of toggler (A). A Push into hole. Rotate toggler (A) clockwise to wedge it against inside walls of metal stud. fig. 1 Slide plastic cap forward while pulling back firmly on ring. Break off excess. Align wall plate with hole in wall and fasten using 1/4-20 x 2.5" screw (B) and 1/4" washer (C). B C wall plate 2 of 2 Visit the Peerless Web Site at www.peerlessindustries.com © 2004 Peerless Industries, Inc. All rights reserved. Peerless is a registered trademark of Peerless Industries, Inc. All other brand and product names are trademarks or registered trademarks of their respective owners. ISSUED: 05-23-02 SHEET #: 120-9012-4 10-29-07 For customer service call 1-800-729-0307 or 708-865-8870.