Download Lopi 564 User's Manual
Transcript
Bostonian (564) Wilmington Face Black 95400186 Compatibility: Nickel 95400187 Packing List: • 564 SS Fireplace • 564 Electric Fireplace • Face • 564 SS Glass Frame Cover • 564 E Side and Hinge Brackets • (2) 564 SS Top Brackets (w screws) • 564 E Upper Heat Shield • (2) 564 SS Upper Mounting Brackets • 564 E Cove Cover • (2) 564 SS Lower Mounting Brackets • (2) 10-24 1-1/2" Screws (564 SS only) • (14) 8-32 Nuts The center deflectors must be in place when using this face to prevent the facing above the fireplace from becoming too hot. If this face is replacing a Lopi Grill (96200801), make sure to replace the center deflectors. Installation Details – 564 SS AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA AAAAAAAAA 29" SIDE OF FIREPLACE 1” 36” 0” TO 1” NOTE: This face has an adjustable bracket that allows for different facing depths to be tucked under the face. Page 1 of 6 8/17/07 © Travis Industries, Inc. Bostonian (564) Wilmington Face Black 95400186 Place the cover over the top of the door frame. Installation – 564 SS 1 Nickel 95400187 Remove the glass frame (see the owner's manual for details). Install glass frame cover as shown to the right. 2 Install face mounting brackets to the fireplace. Push these tabs inwards to lock the cover in place. Remove and discard the nuts and bushings above and below the firebox. Discard the stock bushings and nuts. Upper Bracket Place the upper and lower brackets in place and secure using the nuts included with this kit. Discard the stock bushings and nuts. Lower Bracket Repeat these steps for the opposite side. Upper Upper Left Right Bracket Identification Lower Lower Left Page 2 of 6 Right 6/24/08 © Travis Industries, Inc. Bostonian (564) Wilmington Face Black 95400186 Nickel 95400187 Installation – 564 SS (continued) 3 The facing and hearth (if applicable) must be installed prior to attaching the face. See the installation manual for complete details. Raised Fireplaces AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAAAAAA AAAAAAAA AAAA AAAA AAAA AAAA AAAA AAAAAAAA AAAA AAAA AAAA AAAA Note how the tile is 1” (maximum) above the base of the fireplace. AAA AAA AAA AAAA AAAAAAA AAAA AAA AAA AAAA AAAA AAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAAAAA AAAA AAAAAAA AAAAAA AAAA AAAAAAA AAAAAA AAAA AAAAAAA AAAAAA AAAA AAAAAAA AAAAAA Floor-Level Fireplaces Maximum 1`” Hearth Page 3 of 6 8/17/07 © Travis Industries, Inc. Bostonian (564) Wilmington Face Black 95400186 Nickel 95400187 Installation – 564 SS (continued) 4 Install the face following the directions below. AAA AAA AAA AAA AAA AAA AAAAAA AAA AAA AAAAAA AAA AAA AAA AAA AAA AAA AAA AAA AAA AAA AAA AAAAAAAAA AAA AAA AAA AAA AAA AAA AAAAAAAAA AAA AAA AAA AAA Optional Facing (and/or hearth) -See the installation manual for details. a Attach the upper brackets to the face with the included nuts. The upper bracket consists of two pieces - note orientation. AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA b AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA AAAAAAAAAAAAAAA Slide the face into place. The tabs on the upper brackets insert into the slots on the fireplace c The face is secured to the fireplace with four screws. Two of the screws are fastened to the upper brackets with press nuts. The lower screws are included with the face. brackets, holding the face in place while the screws are tightened. Plated Surfaces Use denatured alcohol and a soft cloth to clean plated surfaces. Marks left on the surface may damage the face. Page 4 of 6 8/17/07 Denatured Alcohol Soft Cloth © Travis Industries, Inc. Bostonian (564) Wilmington Face Black 95400186 Nickel 95400187 Installation – 564 Electric 1 Install the upper heat shield onto the 564 E fireplace. Remove the stock upper heat shield. Place the upper heat shield included with this kit on top of the fireplace (note position of heat shield). Place the stock heat shield on top of it and secure with the same screws. AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAA AAAAA AAAAAAAAAAAA AAAAAA AAA AAAAAAAAAAAA AAAAA AAA AAA AAAAA AAAAAAAAAAAA AAA AAAAAAAAAAAA AAAAA AAA AAAAA AAAAAAAAAAAA AAAAAAAAAAAA Page 5 of 6 AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAA AAAAAAAA AAAAAAAAAAAA AAAAAA AAAAAAAAAAAA AAAA AAAA AAAA AAAA AAAAAAAAAAAA AAAA AAAAAAAAAAAA AAAA AAAA AAAA AAAAAAAAAAAA AAAAAAAAAAAA 8/17/07 © Travis Industries, Inc. Bostonian (564) Wilmington Face Black 95400186 2 Nickel 95400187 Place the face, face down, on a soft, non-scratching surface. Install the 564 Electric mounting brackets onto the back of the face. AAAAAAA AAAAAAAA AAAAAAAA AAAAAAA AAAAAAAA AAAAAAA AAAAAAA AAAAAAAA AAAAAAAA AAAAAAAA AAAAAAA AAAAAAAA AAAAAAAA AAAAAAA AAAAAAAA AAAAAAA AAAAAAA AAAAAAAA AAAAAAAA AAAAAAAA c Remove and AAAAAAA AAAAAAA AAAAAAA AAAAAAA AAAAAAA AAAAAAA 3 a discard the AAAAAAA AAAAAAA AAAAAAA AAAAAAA AAAAAAA AAAAAAA Attach the 564 E side bracket. Use the nuts included with this kit. d Repeat steps “a” through e Before installing the face “c” for the opposite side. verify the lower grill is hinge assembly centered. Loosen the nuts from the face. and adjust if necessary. b Attach the 564 E hinge bracket. Use the nuts removed earlier. Pull the electric fireplace out of the mantel (or built-in location). Attach the cove cover and face following the directions below. Slide the fireplace back into place to complete the installation. Hang the 564 E cove cover over the glass this keeps light from exiting the grill opening along the top of the face. c Lift the face up slightly, tilt it forward and insert the top hooks until the face locks in place. a AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAA AAAAAA AAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAA AAA AAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAA AAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAA AAAAAAAAAAAAA AAAAAAAAAAAA AAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA b AAAAAAAAAAAA AAAAAAAAAAAA AAAAAAAAAAAA Tilt the face back slightly and insert the bottom hooks into the slots on the fireplace. Page 6 of 6 8/17/07 © Travis Industries, Inc.